6
Notes
•To replace the front cap, align it with your flow generator (B-4) and push it firmly until it
clicks into place.
•Remember to take the front cap with you when travelling, in case you need CPAP
therapy without a humidifier.
REMOVING AND STORING THE CONNECTOR PLUG
Please refer to the illustrations in section C of the illustration sheet.
Before attaching the HUMIDAIRE 3i, remove the connector plug from your flow
generator (C-1) and attach it to the back of the docking station (C-2).
ATTACHING YOUR HUMIDAIRE 3i
Please refer to the illustrations in section D of the illustration sheet.
1Align your HUMIDAIRE 3i with your flow generator (D-1) and push them together
until they click into place (D-2).
!
WARNING
•The HumidAire 3i docking station should only be connected or disconnected
when the water chamber is empty.
•Water must be prevented from entering your flow generator. Do not transport
the flow generator with the HumidAire 3i attached.
2Insert the power cord into the socket at the rear of your flow generator. Plug the other
end of the power cord into a power outlet (D-3).
Note: If your flow generator is powered via the DC input, the HumidAire 3i is not powered
and humidification output will be reduced.
3Place the combined unit on a firm, level surface near your bed at a level lower than
your sleeping position. Ensure the surface is not sensitive to heat and/or moisture, or
use a protective mat.
!
CAUTION
Be careful not to place the unit where it can be bumped into and knocked over.
4Connect one end of the air tubing firmly onto the air outlet of your HUMIDAIRE 3i
and the other end to your mask (D-4).
FILLING THE WATER CHAMBER
Please refer to the illustrations in section E of the illustration sheet.
!
WARNING
Take care when handling your HumidAire 3i. The water and the water chamber
base may both be hot. Allow ten minutes for the heater plate and any excess water
to cool.
1Release the cover latch (E-1) and lift the cover until it rests in the upright position (E-2).
338284r3.book Page 6 Tuesday, November 14, 2006 1:23 PM