Ricoh A741 manual PC networking

2.9PC networking

In order for the A741 Repro System to work properly, there must be an active network environment, even for a stand-alone A741 Repro Server. Use the procedure below if the A741 Repro print server is not connected to -and participating in- an active network.

Without a previous network installation (or a system without a network card)

•Open the 'Control Panel -/Network' /Adapters /Add

•Choose the 'MS Loopback' adapter from the list and click OK. Depending on uyour specific installation the Windows NT system disk may be needed.

•Select the 'Protocols' tab

•Choose the NetBEUI protocol and press 'Enter' on the packet size question. If NetBEUI is not listed go back to Add and select it from the list and click OK.

•Close the Network routine and re-start the PC.

•To check if the network is functional by double-clicking on 'Network Neighborhood' to see if your PC name is listed (note: this may take several minutes)

Print Server Manual 11 A741