RIDGID MS1290LZ manual Motor Specifications and Electrical Requirements

Revolutions Per Minute (RPM)

The number of turns completed by a spin- ning object in one minute.

Sawblade Path

The area of the workpiece or table top directly in line with either the travel of the blade or the part of the workpiece which will be, or has been, cut by the blade.

Set

The distance that the tip of the sawblade tooth is bent (or set) outward from the face of the blade.

Workpiece

The item on which the cutting operation is being performed. The surfaces of a work- piece are commonly referred to as faces, ends, and edges.

Face

End

Edge

Motor Specifications and Electrical Requirements

Power Supply and Motor Specifications

	WARNING: To reduce the risk of				The A-C motor used on this tool is a non-
	electrical	hazards,	fire	hazards	reversible universal type, having the fol-
	or damage to the tool, use				lowing specifications:
	proper circuit protection. Your
						Voltage	120
	tool is wired at the factory for
						Amperes	15
	operation	using	the	voltage
						Hertz (Cycles)	60
	shown. Connect tool to a power
					Phase	Single
	line with the appropriate voltage
					RPM	4000
	and a 15-amp branch circuit.
	Use a 15-amp time delay type					Shaft Rotation	Clockwise
	fuse or circuit breaker. To					Brake	Automatic
	reduce the risk of shock or fire,
	if power cord is worn or cut, or
	damaged in any way, have it
	replaced immediately.
General Electrical Connections

DANGER: To reduce the risk of electrocution:

1.Use only identical replacement parts when servicing. Servic- ing should be performed by a qualified service technician.

2.Do not use in rain or where floor is wet.

WARNING Do not permit fingers to touch the terminals of plug when installing or removing the plug to or from the outlet.

If power cord is cut, or damaged in any way, have it replaced immediately.

110-120 Volt, 60 Hz. Tool Information

Double Insulated

The miter saw is double insulated to pro- vide a double layer of insulation between you and the tool’s electrical system. All exposed metal parts are isolated from the

internal metal motor components with protecting insulation.

9