Changing the way in which a loop plays (Loop Control)

9

Press the [EXIT] button.

You will exit preparatory settings for loop control.

10

Press a step [1]–[16] button to specify the step for which you

will input a value.

If you want to input the same value for more than one step, hold down the button for one step and press the button(s) for the other step(s).

*It is not possible to input more than one value at each step. If you select a step for which a value has already been input, the existing data will be replaced by the new data.

11

Turn the C3 knob to input the desired value.

Type

Value

Explanation

 

Pitch

-12–12,

Raise or lower the pitch by up to 1 octave in semi-

 

(TIE),

tone steps relative to the original pitch of the loop.

 

A setting of “1” raises the pitch by a semitone, and

 

(REST)

 

“-1” lowers the pitch by a semitone.

 

Trigger

1–4,

Specify the part that will be played.

 

 

— (don’t play),

To stop playback mid-way through, use

.

 

 

Divide

1–16 (12),

Specify which of the 16 or 12 sections will be

 

times 16

(REST)

played.

 

 

The number of divisions is specified in step 7.

 

 

 

 

12

Repeat steps 10 and 11 to make loop control settings.

13

When you are finished making loop control settings, press the [EXIT] or [ ] button.

*The settings you make are temporary. If you want to keep your new settings, you must save them (p. 56).

If the loop control length is set to 2 measures, you can change the measure location by holding down the [SCALE] button to get the display to show the measure number, and pressing the [INC] or [DEC] button. To check the current measure location, press and hold the [SCALE] button. The previous display will reappear when you release the button.

55

Page 55
Image 55
Roland MC-09 owner manual Turn the C3 knob to input the desired value, Type Value Explanation