Applying an effect
3
Use the [INC] and [DEC] buttons to select an effect pattern.
“P” in front of the number indicates a preset effect pattern, “U” indicates a user effect pattern, and “C” indicates a effect pattern saved on a memory card.
You can rapidly switch between preset (P), user (U), and card (C) by holding down the [SHIFT] button and pressing the [INC] or [DEC] button.
4
When selecting a effect pattern from a card, or when switching to another effect pattern while the current effect pattern plays, press the [ENTER] button to finalize your selection.
Depending on the pattern you select, the indicator of the [LEAD], [BASS], or [RHYTHM] button will blink, and the [LOOP CTRL] button's indicator may light (Loop Control: On). This indicates that the selected pattern includes Loop Control settings (p. 53).
| The selected pattern number will blink until you finalize it. |
|
|
|
| |
* | This step is not necessary when selecting a preset or user effect pattern while the | If you switch to a different | ||||
effect pattern while the | ||||||
| pattern is stopped. | |||||
| current effect pattern is still | |||||
* | You cannot select a effect pattern from a card during playback. In this case, the | |||||
playing, playback will change | ||||||
| display will indicate | to the newly selected effect | ||||
Using the knobs to adjust the effect | pattern at the beginning of the | |||||
next measure. However, the | ||||||
|
| |||||
settings | tempo of the previous effect | |||||
pattern will be maintained. | ||||||
|
|
|
|
|
| |
Use the C1, C2, and C3 knobs to adjust the effect settings. The function of each knob will depend on the type of effect, as shown below.
| C1 knob | C2 knob | C3 knob |
|
|
|
|
|
|
|
|
FILTER | Rate | Cutoff frequency | Resonance |
| (modulation speed)* |
|
|
|
|
|
|
ISOLATOR | Low gain | Middle gain | High gain |
|
|
|
|
PHASER | Rate | Modulation depth | Resonance |
| (modulation speed)* |
|
|
|
|
|
|
SLICER | Rate | Time to cut | Pan |
| (interval of cutting)* |
|
|
|
|
|
|
Cutoff frequency: specifies the frequency at which the filter begins to be applied
Resonance: emphasizes the frequency region near the cutoff frequency
* If you select the 
, 
, 
, 
, or 
effect types (p. 44),
it will not be possible to adjust the rate of the filter, phaser, or slicer.
*The adjustments you make here are temporary. If you want to keep the new settings, you must Store them (p. 48).
*For some settings, you can synchronize the rate of the filter, phaser, or slicer to the standard tempo. For details, refer to the table on the next page.
The knob position may not match the actual value of the setting. In this case, turn the knob slightly, and then make the desired setting.
If you want to view the setting of a knob in the display while you adjust it, hold down the [SHIFT] button while you turn that knob.
If you want to check the setting of a knob in the display, hold down the [SHIFT] button and press the [DISPLAY] button. When you do this, the value of each knob will be displayed in the order of C1, C2, and C3.
43
