Saving a loop to a memory card

The loops recorded in the audio looper can be saved on a memory card. Here we will explain how to save individual loops of the specified part.

1.Press the [SETUP] button.

2.Press the [INC] or [DEC] button until the display

indicates “

”.

3.Press the [ENTER] button.

The display will show the save-destination file number (L01– L50).

4.Press one of the audio looper [SEL] buttons to specify the part that you want to save.

5.Use the [INC] and [DEC] buttons to select the save- destination file number.

*Should you decide that you don’t want to carry out the save, press the [SETUP] button or the [EXIT] button.

6.Press the [WRITE] button to begin saving the data.

While the data is being saved, “ ” will appear in the display. When saving is complete, you’re returned to where you were in step 2.

* If the save-destination file number already exists on the

memory card, the display will indicate “

”. If you

want to save the new data by overwriting the old, press the [ENTER] button. If you want to save the data with a different file number, press the [EXIT] button and repeat the procedure from step 2.

* It may take up to three minutes for saving one loop.

7.Press the [SETUP] button.

When you save a loop to a memory card, it is saved in the MC-09’s own original format. This means that loops you create on the MC-09 cannot be loaded or used by a personal computer or hard disk recorder. If you want to use an MC-09 loop on a different device, you will have to record the loop onto that device as an audio signal.

Loading a loop

Here’s how to load a loop from a memory card into the audio looper.

1.Press the [SETUP] button.

2.Press the [INC] or [DEC] button until the display

indicates “ ”.

3.Press the [ENTER] button.

Using a memory card

The display will show one of the file numbers (L01– L50) that have been saved on the memory card.

4.Press one of the audio looper [SEL] buttons to select the part into which the data will be loaded.

5.Use the [INC] and [DEC] buttons to select the load- source file number.

*If you decide you don’t want to load a file, press the [SETUP] button or the [EXIT] button.

6.Press the [WRITE] button to begin loading.

The display will show “ ” while the data is being loaded. When loading is finished, you’re returned to where you were in step 2.

*If a loop already exists in the load-destination part, the display

will indicate “ ”. If it is ok to overwrite this existing data when you load, press the [ENTER] button. If you decide to load the data into a different part, press the [EXIT] button and repeat the procedure from step 2.

*It may take up to three minutes for loading one loop.

7.Press the [SETUP] button.

Deleting a saved loop from memory card

Here’s how to delete a saved loop from memory card.

1.Press the [SETUP] button.

2.Press the [INC] or [DEC] button until the display

indicates “ ”.

3.Press the [ENTER] button.

The display will show one of the file numbers (L01– L50) that have been saved on the memory card.

4.Use the [INC] and [DEC] buttons to select the number of the file that you want to delete.

5.Press the [WRITE] button.

The display will indicate “ ”, asking you to confirm the operation.

*If you decide not to delete the loop, press the [SETUP] button or the [EXIT] button.

6.Press the [ENTER] button to delete the loop.

While the loop is being deleted, the display will show

”. When the loop has been deleted, you’re returned to where you were in step 2.

7.Press the [SETUP] button.

59

Page 59
Image 59
Roland MC-09 owner manual Saving a loop to a memory card, Loading a loop, Deleting a saved loop from memory card