Hardness of surface to mark

Shape of surface to mark

Part 2 Performing Marking

Vickers hardness (HV) of 200 or less

*Note that materials which may crack or split by marking (such as glass, stone, precious stones, china, and porcelain) cannot be marked even if hardness is within the preceding range. Attempting to mark such materials may damage Metaza.

Flat, with no difference in level

- Examples of material that cannot be marked

 

 

Edge of the

Surface to mark

 

material is too high.

is not straight.

Shape of the back of

When placed on the base, the surface to mark must be flat and level.

the surface to mark

- Examples of material that cannot be marked

 

 

 

 

 

 

 

 

 

 

 

 

 

Back surface is

Back surface is

Back surface is

uneven.

not straight.

curved.

About the Marking Area

The marking area of the Metaza MPX-50 is as shown below.

 

 

 

 

 

 

 

 

Important!

 

 

Marking area

When marking is performed in an expanded area (that is,

 

 

 

 

(50 x 50 mm (1-15/16 x 1-15/16 in.))

outside an area of 50 by 50 mm (1-15/16 by 1-15/16 in.)),

 

 

 

 

 

 

 

 

 

 

then depending on the material and the image, unevenness in

Center line

 

Expanded marking area

darkness may occur.

 

(80 x 80 mm (3-1/8 x 3-1/8 in.))

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Center line

50 mm 80 mm

(1-15/16 in.) (3-1/8 in.)

50 mm

(1-15/16 in.)

80 mm

(3-1/8 in.)

15

Page 17
Image 17
Roland MPX-50 user manual About the Marking Area, Marking area