Roland TD-6V owner manual Midi Channel Settings for a Part Midi Part, 102

Chapter 7 Making the MIDI Settings (SETUP/MIDI, BULK DUMP)

ON:

The drum kits are switched when Program Change messages are received from an external MIDI device.

MIDI Channel Settings for a Part (MIDI PART)

For each part, you can specify the channel on which the TD-6V will receive and transmit MIDI messages.

At a setting of “1” through “16,” MIDI messages will be transmitted and received on that channel. When set to “OFF,” MIDI messages for that part are not transmitted.

Drum kit parts and percussion parts can be overlaid and set to “CH 10.” Make the “CH10Priorty (Channel 10 Priority)” setting to determine whether the drum kit part instrument or percussion part instrument is to be sounded when MIDI messages are received (SETUP/MIDI COMMON/ CH10Priorty; p. 98).

In GM mode (p. 99), the part’s channel is predetermined, and thus cannot be changed.

1.While holding down [SHIFT], press [EDIT (SETUP)].

[EDIT] lights.

2.Press [ ] to select “MIDI PART.”

When “GM Mode” is set to “ON,” “GM PART” is displayed, and you cannot make the setting. Make the setting after first setting “GM Mode” to “OFF” (SETUP/ MIDI COMMON/GM Mode; p. 99).

3.Press [ENTER ].

4.Press [ ] or [ ] to select the part to be set.

Select Part

5.Press [+] or [-] to make the setting.

6.When you finish making settings, press [KIT] or [SONG] to end the procedure.

Value

Part CH (Part Tx Rx Channel): CH 1–CH16, OFF

MIDI Messages Stop Function for Specific Parts in GM (General MIDI) Mode (GM PART)

In GM mode, you can make the setting that determines whether or not MIDI messages are to be received for each individual part.

When set to “OFF,” that part’s MIDI messages are not received.

1.While holding down [SHIFT], press [EDIT (SETUP)].

[EDIT] lights.

2.Press [ ] to select “GM PART.”

When “GM Mode” is set to “OFF,” “MIDI PART” is displayed, and you cannot make the setting.

Make the setting after first setting “GM Mode” to “ON” (SETUP/MIDI COMMON/GM Mode; p. 99).

3.Press [ENTER ].

4.Press [ ] or [ ] to select the part to be set.

Select Part

5.Press [+] or [-] to make the setting.

Value

6.When you finish making settings, press [KIT] to end the procedure.

Part Rx Sw (Part Rx Switch): OFF, ON

102