Roland TD-6V owner manual TrigTyp Trigger Type, PD-8, PD Type, PD-80R, PD-120, PD-125, KD-8

Chapter 2 Making the Pad and Trigger Settings (SETUP/TRIG)

3.	Press [ENTER	].	6. Press [+] or [-] to make the setting.
			When rim is selected, "Rim" becomes the set value, and
4.	Strike the pad you wish to set.		no changes can be made to the setting. Select head, then
			make the settings for the head. However, using AUX and
	The setting screen for the struck pad appears.
			TOM4 requires selecting the rim settings for TOM2 and
	You can also make your selection by holding down [Shift]		TOM3.
	and pressing [	] or [ ].

This setting applies to both the head and rim.

5. Find the trigger type for the pad you are using								Value
							7. When you finish making settings, press [KIT] or
		from the following chart.
							[SONG] to end the procedure.
			Pad	Trigger Type	Pad	Trigger Type	TrigTyp (Trigger Type):
		PD-8		PD-8	KD-7	KD Type
							PD-8, PD Type, PD-80R, PD-120, PD-125, KD-8,
		PD-6		PD Type	KD-80
							KD Type, CY-8, CY Type, RT-7K, RT-5S, RT-3T,
		PD-7			KD-85
							RIM
		PD-9			KD-120
		RP-2		PD-80R	CY-8	CY-8
		PD-80			CY-6	CY Type	Connecting Two Pads to Trigger Input
		PD-80R			CY-12H
							5/6 (TOM2/AUX) and 7/8 (TOM3/4)
		PD-85			CY-12R/C
							1. With a single pad connected to each of the
		PD-100			CY-14C
		PD-120		PD-120	CY-15R		trigger inputs, carry out Steps 1-3 as described
		PD-105		PD-125	RT-7K	RT-7K	above.
		PD-125			RT-5S	RT-5S
							2. Select a pad by striking the pad's rim.
		KD-8		KD-8	RT-3T	RT-3T
					Rim Edge	Rim	If using Trigger Input 5/6 (TOM2/AUX), select the
							TOM2 rim; to use Trigger Input 7/8 (TOM3/4), select the
							TOM3 rim.
	• Use the “RT-7K,” “RT-5S,” or “RT-3T”setting when you
							You can also make your selection by holding down [Shift]
		use acoustic drums to sound the TD-6V. For details refer
							and pressing [ ] or [ ].
		to “Using the TD-6V with Acoustic Triggers” (p. 75).
		There may be no improvement of conditions when non-
		Roland pads are used, even after changing the trigger					3. Press [-] to change the trigger input number
		parameter settings. For fullest expression in performance,					and name to "AUX:H06" or "TOM4:H08" and
		we recommend the exclusive use of Roland pads.					enable AUX or TOM4.

70