72

Chapter 2 Making the Pad and Trigger Settings (SETUP/TRIG)

fig.02-006_50

Sensitivity: 1–16

Setting the Minimum Levels for the Pads (Threshold)

This setting allows a trigger signal to be received only when
the pad is struck harder than a specified force. This can be
used to prevent a pad from sounding in response to
extraneous vibrations from another pad.In the following
example, B will sound but A and C will not sound.

fig.02-007.e

When set to a higher value, no sound is produced when the
pad is struck lightly.
Gradually raise the “Threshold” value while striking the pad.
Check this and adjust accordingly. Repeat this process until
you get the perfect setting for your playing style.

fig.02-008_50

Threshold: 0–15

Adjust How Playing Dynamics Changes the Volume (Trigger Curve)

This setting allows to control the relation between the velocity
(striking force) and changes in volume (the dynamic curve.)
Adjust this curve until the response feels as natural as
possible.

fig.02-009_50

TrigCurve (Trigger Curve):

LINEAR, EXP1, EXP2, LOG1, LOG2, SPLINE,

LOUD1, LOUD2

LINEAR:

The standard setting. This produces the most natural correspondence

between the strength of the strike and the change in volume.

fig.02-010.e

EXP1,EXP2:

Compared to LINEAR, a strong strike will produce a greater change.

fig.02-011.e

LOG1,LOG2:

Compared to LINEAR, a soft strike will produce a greater change.

fig.02-012.e
Threshold
CBA
Volume
Striking Force
LINEAR
Volume Volume
Striking Force
EXP2EXP1
Volume Volume
Striking Force
LOG2LOG1
TD-6KV_e.book 72ページ ２００５年１月２４日　月曜日　午後７時４分