106

Chapter 8 Features Using MIDI and Setting Examples

Combining with an External

MIDI Sequencer

Importing Sequence Data from an

External MIDI Device to the TD-6V’s

Internal Sequencer

You can load data created on another sequencer from the
MIDI IN connector and record the data on the TD-6V’s
sequencer, then use the data as a song. The backing part (Parts
1–4), percussion part, and drum kit part can be imported
simultaneously.

When TD-6V’s instruments are changed from an external
MIDI device, the change is not recorded by the TD-6V’s
sequencer. Use the TD-6V to make each part’s instrument
settings.

For more on external MIDI device operations, refer to the
owner’s manuals for the devices you are using.

1.

Use a MIDI cable to connect the MIDI IN
connector of the TD-6V to the MIDI OUT
connector of the external MIDI device.

fig.08-002.e

2.

Match the MIDI channel to be used for
transmitting data from the external MIDI device
and the MIDI channel that the TD-6V will use for
receiving the data.
(SETUP/MIDI PART/CH; p. 102)
3.
Set “CH10Priorty (Channel 10 Priority)” as
needed when recording drum and percussion
performances.
(SETUP/MIDI COMMON/CH10Priorty; p. 98)
4.
Set “Sync Mode” to “EXT” in order to
synchronize the TD-6V to the external
sequencer. (SETUP/MIDI COMMON/Sync Mode)
5.
Select one of the TD-6V’s new User songs (p.
83).

You can select a new User song by holding down [SHIFT]
and pressing [STOP ] while in the Song screen.

New User songs are indicated by “ ” in the display.

6.

Make the settings for the TD-6V’s parts.
(SONG/PART; p. 87)

Specify the part instruments and percussion sets, volume
levels, etc.

7.

Press [REC ], then make the recording
settings (p. 93).

Time Sig:

Set the beat (time signature) to comply with
that of the loaded data.

Rec Mode:

Set this to “REPLACE.”

8.

Start playback of the external MIDI device.

The TD-6V automatically begins recording.

9.

When you have finished recording, stop the
recording of the external MIDI device.

The TD-6V stops recording automatically.

Recording Your Performance to an

External Sequencer

This makes the settings that allow performances of the pads to
be recorded by an external MIDI sequencer.

1.

Use a MIDI cable to connect the TD-6V and MIDI
sequencer MIDI connectors as shown in the
following figure.

fig.08-003.e

2.

Set Local Control to “OFF.”
(SETUP/MIDI COMMON/LocalControl; p. 97)
MIDI OUT MIDI IN
TD-6VExternal MIDI Sequencer
TD-6V
OUT OUT ININ
External MIDI Sequencer
TD-6KV_e.book 106 ページ ２００５年１月２４日　月曜日　午後７時４分