101
Chapter 2 Using the XV-5080 Effects
Chap.2
85: CLEAN GUITAR MULTI B
Clean Guitar Multi 2 provides Auto-wah (AW), Equalizer
(EQ), Delay (Dly), and Chorus or Flanger (CF) effects
connected in series.
fig.02-085m.e
Seqeuence
Wah (Auto Wah Switch)
Turns the Auto Wah on/off.
3 Band EQ (3 Band EQ Switch)
Turns the 3 Band EQ on/off.
Delay (Delay Switch)
Turns the Delay on/off.
Cho/Flg Sw (Chorus/Flanger Switch)
Turns the Chorus/Flanger on/off.
Wah
Filter Type (Auto Wah Filter Type)
Selects the type of filter for the Auto-wah.
LPF: The wah effect will be applied over a wide frequency
range.
BPF: The wah effect will be applied over a narrow frequency
range.
Rate (Auto Wah Rate)
Sets the modulation speed of the Auto-wah.
Depth (Auto Wah Depth)
Sets the modulation depth of the Auto-wah.
Sens
Specifies the sensitivity with which the filter will be affected.
Manual (Auto Wah Manual) #
Sets the center frequency at which the auto-wah effect will be
produced.
Peak (Auto Wah Peak)
Adjusts the amount of the wah effect that will occur in the
area of the center frequency. Lower settings will produce a
wah effect in a broad area around the center frequency, and
higher settings will produce a wah effect in a narrower area
around the center frequency.
EQ Gain
Low (EQ Low Gain)
Adjusts the low-range gain of the equalizer.
Mid (EQ Mid Gain)
Adjusts the gain of the area specified by the EQ M Fq
parameter and the EQ M Q parameter.
High (EQ High Gain)
Adjusts the high-range gain of the equalizer.
Mid
Mid Freq (EQ Mid Frequency)
Sets the center frequency for the equalizer mid-range.
Mid Q (EQ Mid Q)
Adjusts the width of the area centered at the EQ M Fq setting
in which the gain will be affected. Higher values of Q will
result in a narrower area being affected.
Delay
Left Time (Delay Time Left)
Adjust the delay time from the original sound until the left
delay sound is heard.
Right Time (Delay Time Right)
Adjust the delay time from the direct sound until the right
delay sound is heard.
Feedback (Delay Feedback Level)
Adjusts the proportion (%) of the delay sound that is fed
back into the delay input.
HF Damp (Delay HF Damp)
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to damp the high
frequencies, set this parameter to BYPASS.
Balance (Delay Balance) #
Adjusts the volume balance between the direct sound and
the delay sound.
L out
R out
L in
R in
Wah
Delay Chorus/
Flanger Pan
3-Band EQ