Roland XV-5080 Chapter 2 Using the XV-5080 Effects, 64: STEREO PHASER 2

80
Chapter 2 Using the XV-5080 Effects
The teeth in SAW1 and SAW2 point at opposite directions.
fig.2-73a
Rate #
Adjust the frequency (speed) of the change.
Depth #
Sets the depth to which the effect is applied.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Output
Level (Output Level)
Adjust the output level.
64: STEREO PHASER 2
This is a stereo phaser.
fig.02-064m.e
Phaser
Type (Phaser Type)
Selects the type of Phaser.
Type 2 adds more of the Phaser effect to the high frequencies
than Type 1.
Mode
Selects the number of stages in the phaser (4/8/12/16).
Polarity
Selects whether the left and right phase of the modulation
will be the same or the opposite.
INVERSE: The left and right phase will be opposite. When
using a mono source, this spreads the sound.
SYNCHRO: The left and right phase will be the same. Select
this when inputting a stereo source.
Manual #
Adjusts the center frequency to which the phase effect is
applied.
Rate (Phaser Rate) #
Specifies the frequency of modulation.
Depth (Phaser Depth)
Adjusts the depth of modulation.
Resonance (Phaser Resonance)
Adjusts the amount of feedback for the phaser. Higher
settings will give the sound a stronger character.
X-Feedback (Cross Feedback Level)
Adjusts the proportion (%) of the phaser sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
Mix Level (Mix Level)
Specifies the volume of the phase-shifted sound, relative to
the direct sound.
Step Rate
Switch (Step Switch)
Determines whether the pitch is changed in a stepped
fashion (ON) or not (OFF).
Rate (Step Rate) #
Adjusts the rate (period) of pitch change.
EQ Gain
Low (Low Gain)
Adjusts the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low-
frequency range.
High (High Gain)
Adjusts the gain of the high frequency range.
Positive (+) settings will emphasize (boost) the high-
frequency range.
Saw1 Saw2
R in R out
L in L out
Phaser Mix
2-Band
EQ
Phaser 2-Band
EQ
Mix