71
Chapter 2 Using the XV-5080 Effects
Chap.2
HF Damp
Adjust the frequency above which delayed sound fed back to
the delay input will be cut.
If you do not want to cut the high frequencies of the
feedback, set this parameter to BYPASS.
Feedback #
Adjust the proportion (%) of the delay sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
Delay Level
Center (Level Center)
Adjust the volume of the left delay sound.
Left (Level Left)
Adjust the volume of the center delay sound.
Right (Level Right)
Adjust the volume of the right delay sound.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Output
Out (Output Mode)
Adjust the method that will be used to hear the sound that is
output to the OUTPUT jacks. The optimal 3D effect will be
achieved if you select SPEAKER when using speakers, or
PHONES when using headphones.
Level (Output Level)
Adjust the output level.
49:3VOICE PITCH SHIFTER
A Pitch Shifter shifts the pitch of the original sound. This 3-
voice pitch shifter has three pitch shifters, and can add three
pitch shifted sounds to the original sound.
fig.2-58
Pch Coarse
1:2:3 (Coarse Pitch 1:2:3) #1
Specify the pitch in semitones for pitch shift 1–3.
Pch Fine
1:2:3 (Fine Pitch 1:2:3) #1
Make fine adjustments to the pitch of the pitch shift 1–3 in 2-
cent steps.
Pitch Shift
Mode (Pitch Shifter Mode)
Higher settings of this parameter will result in slower
response, but steadier pitch.
Fbk 1:2:3 (Feedback Level 1:2:3)
Adjust the proportion (%) of the pitch shift 1–3 sound that is
fed back into the effect.
Pre Delay 1:2:3 (Pre Delay Time 1:2:3)
Specify the time delay from the original sound until the pitch
shift 1–3 sound is heard.
Balance
Balance (Effect Balance)
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W the effect sound will
be output.
Level (Output Level)
Specifies the output volume.
L
R
Pitch 1
Pitch 3
Pitch 2
L out
R out
1
2
3