90
Chapter 2 Using the XV-5080 Effects
Tremolo/Pan
Type
Selects either Tremolo or Pan.
ModWave (Modulation Wave)
Selects the way in which tremolo or pan will be modulated.
Tri: The sound will be modulated like a triangle
wave.
Sqr: The sound will be modulated like a square
wave.
Sin: The sound will be modulated like a sine wave.
Saw1,2: The sound will be modulated like a sawtooth
wave.
The teeth in SAW1 and SAW2 point at opposite directions.
Rate (Modulation Rate) #
Specifies the rate of modulation.
Depth (Modulation Depth) #
Specifies the depth of modulation.
Output
Level (Output Level)
Adjusts the output level.
75: JD MULTI
This allows the Distortion (DS), Phaser (PH), Spectrum (SP),
and Enhancer (EH) effects to be connected in series in any
desired order.
fig.02-075m.e
SEQUENCE
Dist (Distortion Switch)
Turns the Distortion on/off.
Phaser (Phaser Switch)
Turns the phaser on/off.
Spectrum (Spectrum Switch)
Turns the Spectrum on/off.
Enhancer Sw (Enhancer Switch)
Turns the Enhancer on/off.
* After turning the VALUE dial to select the effect, you can hold
down [SHIFT] and press [F1] or [F2] to rearrange the order in
which effects are connected.
Distortion
Type (Distortion Type)
Specifies the type of the distortion.
MELLOW DRIVE: A soft, mellow distortion; somewhat dark
sounding.
OVERDRIVE: The classic sound of an overdriven tube amp.
CRY DRIVE: Distortion with a high-frequency boost.
MELLOW DIST: Sounds like the distortion you’d get from a
really big amp.
LIGHT DIST: A distortion with an intense, brilliant feel.
FAT DIST: Boosted lows and highs gives this one a thick, fat
sound.
FUZZ DIST: Like FAT DIST, but with even more distortion.
Drive (Distortion Drive) #
Adjusts the degree of distortion.
Level (Distortion Level)
Sets the distortion output level.
Phaser
Manual (Phaser Manual) #
Specifies the center frequency at which the sound is
modulated.
Mix Level #
Specifies the volume of the phase-shifted sound, relative to
the direct sound.
Rate (Phaser Rate) #
Specifies the frequency of modulation.
Depth (Phaser Depth) #
Adjusts the depth of modulation.
Resonance (Phaser Resonance) #
Adjusts the amount of feedback for the phaser. Higher
settings will give the sound a stronger character.
Spectrum
Band Width
Specifies the range of all bands in which the level will be
L out
R out
L in
R in
Distortion
Spectrum Enhancer
Phaser