67
Chapter 2 Using the XV-5080 Effects
Chap.2
setting is the vowel 2.
Rate
Sets the frequency at which the two vowels will be switched.
Depth
Sets the effect depth.
Manual
Sets the point at which the two vowels will be switched.
When set to 50, Vowels 1 and 2 switched in the same amount
of time. Setting this higher than 50 increases the time for
Vowel 1; setting this lower than 50 decreases the time for
Vowel 1.
Keysync
Switch (Keysync Switch)
Determines whether the LFO for switching the vowels is
reset according to the input sound (ON) or not (OFF).
Thres (Keysync Threshold)
Specifies the volume level for which reset will be applied.
EQ Gain
Low (Low Gain)
Specifies the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Specifies the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Output
Level (Output Level)
Specifies the output volume.
Pan (Output Pan)
Specifies the stereo location of the output sound. L64 is far
left, 0 is center, and 63R is far right.
44:RING MODULATOR
Ring Modulator is an effect which applies amplitude
modulation (AM) to the input signal, producing bell-like
sounds.
You can also change the modulation frequency according to
the volume of the sound input to the effects device.
fig.2-54
Ring Modulator
Freq (Frequency) #
Sets the frequency at which modulation will be applied.
Modulator (Modulator Source)
Selects the input of the source sound for the envelope
controlling the modulation.
When set to SOURCE, the frequency is modulated according
to the envelope of the sound input to the multi-effects.
Modulator Monitor
Determines whether the input sound used as the modulator
is output (ON) or not (OFF).
Sens #
Sets the amount of frequency modulation applied.
Polarity
Determines whether the frequency modulation moves
towards higher frequencies (UP) or lower frequencies
(DOWN).
EQ Gain
Low (Low Gain)
Specifies the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Specifies the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W the effect sound will
be output.
L in
R in
L out
R out
Ring Mod
2-Band EQ
2-Band EQ
Ring Mod