99
Chapter 2 Using the XV-5080 Effects
Chap.2
Feedback (Delay Feedback Level)
Adjusts the proportion (%) of the delay sound that is fed
back into the delay input.
HF Damp
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to damp the high
frequencies, set this parameter to BYPASS.
Balance (Delay Balance) #
Adjusts the volume balance between the direct sound and
the delay sound.
Chorus/Flanger
Type
Selects either Chorus or Flanger.
Rate
Sets the modulation speed for the chorus or flanger.
Depth
Sets the modulation depth for the chorus or flanger.
Feedback (CF Feedback)
Adjusts the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Pre Delay (Chorus/Flanger Pre Delay Time)
Adjusts the delay time from the direct sound until when the
chorus sound is heard.
Balance #
Adjusts the volume balance between the direct sound and
the chorus/flanger sound.
Filter
Type
Selects the type of filter.
OFF: No filter is used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
Output
Level (Output Level)
Adjusts the output level.
Pan (Output Pan) #
Adjusts the stereo location of the output sound.
84: CLEAN GUITAR MULTI A
Clean Guitar Multi 1 connects Compressor (Cmp), Equalizer
(EQ), Delay (Dly), and Chorus or Flanger (CF) effects in
series.
fig.02-084m.e
Sequence
Comp (Compressor Switch)
Turns the Compressor on/off.
3 Band EQ (3 Band EQ Switch)
Turns the equalizer on/off.
Delay (Delay Switch)
Turns the Delay on/off.
Cho/Flg (Chorus/Flanger Switch)
Turns the wah on/off.
Compressor
Attack (Compressor Attack)
Specifies the duration of the attack when sound is input.
Sustain (Compressor Sustain)
Specifies the time over which low-level sounds will be
boosted to reach the specified volume. Increasing the value
will shorten the time.
* When the value is modified, the level will also change.
Level (Compressor Level) #
Sets the volume of the compressor sound.
L out
R out
L in
R in
Compressor
Delay Chorus/
Flanger Pan
3-Band EQ