116
Chapter 3 Selecting Output Jacks
SYSTEM Output page ([SYSTEM] - [F2 (OutP&EQ)])Output Mix/Parallel
Mode
Available Settings:
MIX: Signals that are set to be output from jacks other than
the A (MIX) OUTPUT jacks are mixed and output from the A
(MIX) OUTPUT jacks. This setting allows you to quickly
route everything through headphones when you are creating
sounds, or to combine all of your sounds into two outputs
when sending the XV-5080’s signal to a mixer that has only
two channels.
When MIX is selected, sounds routed to the INDIVIDUAL
OUTPUT 3/5/7 jacks are sent to the left A (MIX) OUTPUT
jack, and sounds routed to the INDIVIDUAL OUTPUT 4/6/
8 jacks are sent to the right A (MIX) OUTPUT jack.
PARALLEL: Sounds are routed to output jacks according to
their output settings.
The XV-5080’s Master Level and Mix/Parallel settings are
each established using a single global parameter.
SYSTEM General #1 page ([SYSTEM] - [F1 (General)])
Master
Level (Master Level)
Range: 0–127
Adjusts the volume of the entire XV-5080.
Example Settings
Setting the Output Destination of a Specific Rhythm Tone
This example explains the procedure for outputting the
Rhythm Tone assigned to C4 from the INDIVIDUAL 3
OUTPUT jack without sending it through any internal
effects.
1. Select the Rhythm Set you wish to set.
2. Press [F6 (Effects)].
3. Press [F1 (General)] to call up the RHYTHM Effects
General page.
4. Press TONE SELECT [1]–[4] and set the key at the upper
left corner of the display to “C4.”
* If a MIDI keyboard is connected, you can select C4 by pressing
the C4 key on the keyboard.
5. Press [ ]/[ ]/[ ]/[ ] to move the cursor to
Rhythm Tone Output Assign.
6. Turn the VALUE dial or press [INC]/[DEC] to select “3.”
7. Press [ ]/[ ]/[ ]/[ ] to move the cursor to
Rhythm Tone Dry Send Level.
8. Turn the VALUE dial to select “100.”
9. Press [ ]/[ ]/[ ]/[ ] to move the cursor to
Rhythm Tone Chorus Send Level.
10.Turn the VALUE dial to select “0.”
11.Set the Rhythm Tone Reverb Send Level setting to “0” in
the same way.
12.Press [EXIT] to return to the RHYTHM PLAY page.
13.Press [F1 (Common)].
14.Press [ ]/[ ] to move the cursor to Output Assign.
15.Turn the VALUE dial or press [INC]/[DEC] to select
“TONE.”
16.Press [EXIT] to return to the RHYTHM PLAY page.