54
Chapter 2 Using the XV-5080 Effects
Modulation
Rate #
Adjust the speed of the modulation.
Depth
Adjust the depth of the modulation.
Phase
Adjust the spatial spread of the sound.
EQ Gain
Low (Low Gain)
Adjust the gain of the low frequency range.
High (High Gain)
Adjust the gain of the high frequency range.
Balance
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
modulation delay sound. With a setting of D100:0W only the
direct sound will be output, and with a setting of D0:100W
only the modulation delay sound will be output.
Output
Level (Output Level)
Adjust the output level.
19: TRIPLE TAP DELAY
The Triple Tap Delay produces three delay sounds; center,
left and right. The center delay time can be specified as a note
value of a specified tempo.
fig.2-24
Delay
Center (Delay Time Center)
Left (Delay Time Left)
Right (Delay Time Right)
Adjust the time delay from the direct sound until when the
delay sound is heard. This parameter can be set as a note-
value of a specified tempo. In this case, specify the value of
the desired note.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Feedback #
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Delay Level
Center (Center Level)
Left (Left Level)
Right (Right Level)
Adjust the volume of each delay sound.
EQ Gain
Low (Low Gain)
Adjust the gain of the low frequency range.
High (High Gain)
Adjust the gain of the high frequency range.
L in
R in
L out
R out
Left Tap
Right Tap
Triple Tap Delay
2-Band
EQ
2-Band
EQ
Balance W
Balance D
Balance W
Balance D
Feedback
Center Tap