157
Chapter 4 Creating Patches
Chap.4
Rate (LFO Rate)
Range: 0–127
Adjusts the basic modulation rate, or speed, of the LFO.

Detune (LFO Rate Detune)

Range: 0–127
Changes the rate of the LFO.
Delay (LFO Delay)

Time (LFO Delay Time)

Range: 0–127
This sets the time interval between the moment when a key is
pressed (or released) and the moment the LFO begins to take
effect. (Refer to the diagrams for Fade Mode.)

Keyfolw (LFO Delay Keyfollow)

Range: -63– +63
Adjusts the value for the LFO1 Delay Time parameter
depending on the key position, relative to the C4 key (center
C). To decrease the time that elapses before the LFO effect is
applied (the effect is continuous) with each higher key that is
pressed in the upper registers, select a positive value; to
increase the elapsed time, select a negative value. Higher
values will cause greater change. If you do not want the
elapsed time before the LFO effect is applied (the effect is
continuous) to change according to the key pressed, set this
to “0.”
Key Sync
Range: OFF/ON
Specifies whether you want the LFO cycle to start in sync
with the timing of a key press (ON), or not (OFF).
Depth (LFO Depth)

Pitch (Pitch LFO Depth)

Range: -63– +63
Adjusts how much the LFO will affect the WG Pitch.

TVF (TVF LFO Depth)

Range: -63– +63
Adjusts how much the LFO will affect the Tone’s TVF cutoff
frequency.

TVA (TVA LFO Depth)

Range: -63– +63
Adjusts how much the LFO will affect the Tone’s TVA Level.

Pan (Pan LFO Depth)

Range: -63– +63
Adjusts how much the LFO will affect the Tone’s TVA Pan.
PATCH LFO&Ctrl Control #1/#2 page ([PATCH] - [F5 (LFO&Ctl)] - [F2 (Control)])
fig.04-074.e_70
Matrix Control 1–4
Source (Matrix Control Source)
Assign one of the following controllers to Matrix Control
Source. If you wish to use a controller that will apply to all
Patches, or a controller that cannot be directly selected here,
select SYS-CTRL1–4, and then select the controller using the
System Control Source parameters (System Control screen).
Available Settings:
OFF: No controller is used.
CC01–CC95: Controller numbers 1–95 (except for 32)
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS-CTRL1: System controller 1
SYS-CTRL2: System controller 2
SYS-CTRL3: System controller 3
SYS-CTRL4: System controller 4
VELOCITY: Velocity
KEYFOLLOW: Keyfollow
TEMPO: Tempo
LFO1
LFO2 *1
PITCH ENV: Pitch envelope *1
TVF ENV: TVF envelope
TVA ENV: TVA envelope
* Parameters with a "*1" are disabled in Multi-Partial Patches.