Runco VX-6000D operation manual Turning on the Power, VX2000/6000, Hdmi, 1691080i/60

Installation

Connecting to AC Power ➤ Projector/DHD Controller: The VX-6000d system includes two (2) AC power cords (one each for the projector and DHD Controller).

Plug the female end of one power cord into the AC receptacle on the rear of the

VX-6000d (AC 100V ~ 240V). Then, connect the other end to your AC power source.

Similarly connect the DHD Controller to a nearby AC outlet.

AutoScope Lens Motor: With AutoScope-equipped projectors, a third power cord is provided for the lens motor. Plug the female end of the AC power cord into the AC input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power source.

The input voltage to the AutoScope lens motor must be between

Caution 100 and 120 VAC. Do not connect the AutoScope lens motor to a 200-240 VAC power source!

3.7

Turning on the Power

1.Turn on your source components.

2.Turn on the main power switch at the rear of the DHD Controller.

3.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input (see Figure 3-17).

4.Press the ON button on the remote control – or the ON/STANDBY ( ) button on the DHD Controller front panel – to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Initializing System,” followed by “Starting VX-2000/6000.”

5.When the projector has completed its initialization and is ready for use, the fluorescent display on the DHD Controller indicates the active source, input resolution/frame rate and aspect ratio; for example:

Current

Source

VX2000/6000 HDMI 1

16:91080i/60

Aspect Ratio Input Resolution/Frame Rate

42 Runco VX-6000d Installation/Operation Manual