Samsung SRD-1610, 870D, 1670D, 1650D, SRD-850D, SRD-830 Remote Devices, POS Devices, using the DVR

using the DVR

~Duration : Sets the alarm duration for the alarm signal and beep sound.

-Check Alarm, Replace Alarm signals will output through the selected alarm out ports (1, 2, 3, and 4).

-If <BEEP> was selected, a beep will sound.

-If <All> was selected, both beep sound and alarm signal through rear side ports will output.

M	` <Check> status means that the HDD is operating but it has problems that require technical examination.
	(	) appears on the Live screen.

`<Replace> status means that the HDD has defect and requires immediate replacement.

( ) appears on the Live screen.

6.When the HDD Alarm setup is done, press <OK>.

Remote Devices

You can set the RS-485 communication for use of PTZ Camera and system keyboard with the DVR.

Using the mouse may help make setup easier.

3.Use the up/down buttons (▲▼) in <Device> window to move to <Remote Device>, and press [ENTER] button.

4.Use direction buttons (▲▼_ +) to move to the desired item, and press [ENTER] button.

5.Set the values of each communication setup of the remote device.

~Baudrate : Baud rate settings of the DVR, PTZ camera and system keyboard should be matched for proper operations.

6.Make sure to match IDs of the DVR, System Keyboard and Remote Control, and press <OK>.

Remote Device
Baudrate		Parity		Data		Stop Bit		Transfer type
9600		None		8		1		Half Duplex	
System Keyboard		OFF		ID	00
Remote Control		ON		ID	00
			OK		Cancel

M ` For changing the remote control’s ID, refer to “Changing the Remote Control ID”. (Page 14)

POS Devices

You can set properties of POS devices connected to the DVR.

A POS device connection requires channel, preset, and Port/Ethernet settings.

Using the mouse may help make setup easier.

3.Use the up/down buttons (▲▼) in <Device> window to move to <POS Device>, and press [ENTER] button.

4.Use direction buttons (▲▼_ +) to move to a desired item, and set the value.

~POS USE : When selected <POS USE>, DVR and POS will be connected.

J	` If you change settings for the device and press <OK> while
	the <POS USE> is not checked, the changes for POS device
	will not be saved.

POS Device

POS USE

POS Device Setup

POS	CH	Preset 		Port/Ethernet
1	None	No preset		None
2	None	No preset		None
3	None	No preset		None
4	None	No preset		None
5	None	No preset		None
6	None	No preset		None
7	None	No preset		None
8	None	No preset		None
				Previous/Next Page
		OK	Cancel

50_ using the DVR