Samsung 870D, 1670D, 1650D Changing the Remote Control ID, Channel, Press any button among 1 to

overview

MONITOR

Available after switching to Monitor mode by pressing the [MONITOR] button on the remote control.

AUTO	ID RESET
Selects the screen status automatically.	Initializes the ID value to 00.
P.MODE
Selects the screen mode.

POWER Turns the monitor power on/off.

MONITOR

Activates the monitor function.

NUMBER [0~9]

Changes the system ID.

ID

Sets the ID.

Select 2 digits from 0 ~ 9 while pressing the ID Key.

+/–	MUTE
Adjusts the audio volume.	Mutes the audio out.
MENU
Displays the Setup Menu.
Up/Down/Left/Right($%_ +)/ENTER
Moves the cursor up/down/left/right, and runs the
Select Menu.
FREEZE
Screen Freeze.
	SOURCE
UNDER SCAN	Selects the input signal source.
	PIP
Displays the video screen within a screen.	Selects or deselects the PIP function.

Using the Numeric buttons

CHANNEL 1–9

Press any button among 1 to 9.

Changing the Remote Control ID

1.Press the ID button of the remote control and check the ID displayed on the DVR screen. The factory default ID of the remote control is 00.

2.Enter 2 digits of your selection in order, while pressing the system [ID] button.

3.When ID input is done, press the system [ID] button again to check the setting.

M	` If you want to change the remote control ID to 08: Press 0 and 8 in order while the system [ID] button is pressed.
	Remote control's ID and DVR’s ID should be matched for proper operation. Refer to “Remote Devices”. (Page 50)

14_ overview