Initial setup
Initial cleaning
Before the oven is used for the first time, it should be cleaned thoroughly. Do not use any abrasive cleaning agents, cloths or substances, because they could damage the oven surfaces.
Use warm water, detergent and soft clean cloth to clean the baking tray, dripping tray, grids and the other accessories, as well as the internal compartment and the guide rails at the oven sides. The front should be cleaned with damp, soft and clean cloth.
Check if the oven clock is set correctly and remove all accessories from the oven. Run oven in single mode with convection for one hour at 200 °C. This procedure will burn any remaining production substances in the oven with an unmistakeable odour. This is normal, though make sure your kitchen is well ventilated during that time.
Troubleshooting
PROBLEM | SOLUTION |
What should I do if the oven | • The oven may not be switched on. Switch the oven on. |
doesn’t heat up? | • The clock may not be set. Set the clock. |
| • Check to see if the required settings have been applied. |
| • A household fuse may have blown or a circuit breaker |
| may has tripped. |
| Replace the fuses or reset the circuit. If this happens |
| repeatedly, call an electrician. |
What should I do if the oven | • There may be problems with the internal electrical |
doesn’t heat up even after the | connections. Call your local service centre. |
function and temperature have |
|
been set? |
|
What should I do if an error | • There is a fault in the internal electrical circuit |
code appears and the oven | connection. Call your local service centre. |
does not heat up? |
|
What should I do if the time | • There has been a power failure. Set the clock. |
display is blinking? |
|
What should I do if the oven | • The oven light is faulty. Call your local service centre. |
light doesn’t illuminate? |
|
What should I do if the oven’s | • After use, the oven’s fan runs until the oven has cooled |
fan is running without having | down. Call your local service centre if the fan continues |
been set? | to run after the oven has cooled down. |
Information codes
| CODE | PROBLEM | SOLUTION | |
|
|
| Safety shut off. The oven continues | Turn oven off and remove food. Allow |
|
|
| ||
|
|
| operating at the set temperature for a | oven to cool before using it again. |
|
|
| prolonged time. |
|
|
|
| Key is pressed for over 10 seconds. | Call your local SAMSUNG Customer Care |
|
|
| ||
|
|
|
| Centre. |
|
|
|
| |
|
|
| Divider Missing. Divider use is incorrect. | Insert divider for upper, twin and lower |
|
|
| ||
|
|
|
| mode. Remove divider for single mode. |
|
|
|
|
|
|
| An oven error may cause low | Call your local SAMSUNG Customer Care | |
| 1) |
| ||
| ** |
| performance and problems in safety. | Centre. |
|
| |||
|
|
| Stop using the oven immediately. |
|
1) ** refers to all numbers.
22_installation & maintenance
