Antenna + DVD Recorder +

 

Other type of connecting

external decoder box + TV

 

the Video output cable

 

 

 

If you connect external decoder box to DVD recorder, you can record scrambled channels (CANAL+or Premiere broadcasts) received through the built-in TV tuner in DVD Recorder.

Wall

DECODER

1.Connect RF antenna cables as shown.

2.Connect the AV1 connector on this recorder to the SCART AV connector on TV using a SCART cable.

3.Connect the AV2 connector to a SCART AV connector on decoder box.

4.To watch or record PAY-TV Canal Plus programmes, set your DVD Recorder to receive the channels using the on-screen display.(Refer to page 28)

There are several ways to output video signal not using scart cables. Select one of the following video connecting that best suits you below.

●Case 1 : Connecting to a Video (Composite) output jack

●Case 2 : Connecting to an S-Video output jack

●Case 3 : Component Video output jacks

S-Video, Component video and Progressive Output Modes

●S-Video and Component video output are available only if your TV supports S-Video input or Component video input, respectively. If S-Video or Component video output does not work, check the TV connections and the TV input selection settings.

●Compared to standard interlaced video, progressive scan doubles the amount of video lines fed to your TV, resulting in a more stable, flicker-free, clear image than interlaced video.

This is only available with TVs that support progressive scan.

●Progressive Scan Output (576p)

Consumers should note that not all high definition television sets are fully compatible with this DVD Recorder and may cause artifacts to be displayed in the picture, in case of 576 progressive scan picture problems, It is recommended that the user switch the connection to the ‘standard definition’ output. If there are questions regarding our TV set compatibility with this model 576p DVD Recorder, please contact our customer service centre.

Up Setting & onnectingC

English -19