Auto Program

Operation

4 Press the œ or √ button to select the Antenna connection, then press the ENTER button.

•Air : “Air” antenna signal

Cable : “Cable” antenna signal

Air+Cable : “Air” and “Cable” antenna signals

•If a CableCARD is inserted into the “CableCARD” slot on the rear panel, “Cable” and “Air+Cable” are not available.

When selecting Cable TV system:

Press the ENTER button to start the auto program. By default, the cable TV system is set to “STD”.

If you want to select another type of cable system,

press the œ or √ button to select Analog or Digital “STD”, “HRC” or “IRC”.

•STD, HRC and IRC identify various types of cable

TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point the signal source has been selected.

5 Press the ENTER button to start the auto program. The TV begins memorizing all available stations. Press the ENTER button at any time to interrupt the memorization process.

Select “Return” by pressing the … or † button, then press the ENTER button to return to the previous menu.

Press the EXIT button to exit.

•The TV must be connected to an antenna/cable in order to receive digital TV signals. Even if a particular channel is deleted from the memory, you can always tune to that channel directly by using the number buttons on the remote control.

•When connecting Digital Cable to a Set-Top Box, Channel Memorization is done on the STB.

To view the STB on your TV, select the Input jack the STB is connected to with the SOURCE button on the TV’s remote. (see page 49)

Select the antennas to Memorize