Samsung SDE5003, SDE-500X, SDE-5003 Video Loss Detection, Setting the Motion Detection Area

main menu

Setting the Motion Detection Area

Select <Motion Region>.

When “Motion Region” window appears, select a channel for detection and set the area of motion detection.

•To set the area in “Motion Region” window

In the “Motion Region” window, select desired region		Motion Region
from <	>.	CH1
• To set the area using <Individual> selection				Individual Apply to All CH
			OK Cancel
In the “Motion Region” window, you can select cells
individually by using <Individual>.

When selected <Individual>, “Motion Region” window disappears and you can select cells one by one. When the motion area setup is done, press the <Menu> on the screen or the [MENU] button on the remote control or front panel to display the “Motion Region” window again.

- Select : Selected cell is set to be a part of motion detection area.		Select
- Unselect : Selected cell is removed from the motion detection area.		Unselect
-	Inverse : Unselected cells are set to be the motion detection area.	Inverse
-	Menu : After selecting individual motion areas, move to the “Motion Region” window.
		Menu

If selected <Apply to All CH>, selected motion area is applied to all channels.

When the motion detection setup is done, press <OK>.

Video Loss Detection

You can set the alarm to be generated on a camera disconnection, which causes a video loss.

Using the mouse may help make setup easier.

1.	Use the up/down buttons (	) in <Event> window to
			Video Loss Detection
	move to <Video Loss Detection>, and press [ENTER]
			CH	Video Loss State 			Alarm 		Alarm Duration 
	button.
			1	OFF			None		10 sec	
	A window of video loss detection area setup appears.		2	OFF			None		10 sec	
2.			3	Help						
	Use direction buttons (	) to move to a desired	4	OFF			None		10 sec	
					If a video loss event occurs during the event
			5	OFF			None		10 sec	
			6		recording, the POST recording settings of the				10 sec	
				OFF			None
	item, and set the value.				applicable channel will be reset.
			7	OFF			None		10 sec	
			8	OFF			OKNone		10 sec	
• Video Loss State : Sets whether to activate video loss
								Previous/Next Page
	detection.									Help
• Alarm : Sets the alarm output method.						OK	Cancel

For further information on alarm output, refer to “HDD Alarm > Alarm”. (Page 63)

•Alarm Duration : Sets the duration of alarm signal and alarm sound.

•Help : Displays a help message that will appear if a video loss event occurs.

3.When the video loss detection setup is done, press <OK>.

72_ main menu