Samsung SDE-5003, SDE5003, SDE-500X, SDE-400X user manual Setting the Event, Sensor Detection

main menu

SETTING THE EVENT

You can set recording options for sensor, motion, and video loss event.

Setting the <Sensor Detection> is not supported by SDE-4003/5003.

Sensor Detection

You can set the sensor’s operating condition and connected camera, as well as alarm output and its duration.

Using the mouse may help make setup easier.

1.Press the [MENU] button on the remote control or front panel.

2.Use the left/right button (◄ ►) to select <Event>. Event setting menu is selected.

Logout

Event

Sensor Detection

Motion Detection

Video Loss Detection

Alarm Schedule

Return

3.	Use the up/down buttons (	) to move to <Sensor
	Detection>, and press [ENTER] button.
4.	A window of sensor detection setup appears.
	Use direction buttons (	) to move to a desired
	item, and set the value.

•Sensor Operation : Sets the operation mode of sensors.

-<OFF> : Sensor does not operate.

-<N.O (Normal Open)> : Sensor is opened. If the sensor is closed, it generates alarm.

-<N.C (Normal Close)> : Sensor is closed.

If the sensor is open by interruption, it generates alarm.

•Cam : Select a channel to be connected to the sensor. If selected camera, “Camera Setup” window appears. Select a channel and setup the preset.

 SDE-400X could only preset 8 channels.

Sensor Detection
Sensor	Sensor Operation 		Cam 	Alarm 	Duration 
1	OFF		1	None	10 sec	
2	OFF		2	None	10 sec	
3	OFF		3	None	10 sec	
4	OFF		4	None	10 sec	
			OK	Cancel

Sensor Detection
Sensor	Camera Setup				Cam 	Alarm 		Duration 
	Sensor Operation
1		OFF	CH 		1	None	CH 	10 sec	
2	1	OFF			2	None		10 sec	
3		OFF			3	9		10 sec
	2					None			
4		OFF			4	10		10 sec
	3					None			
						11
	4					12
	5					13
	6					14
	7					15
	8					16
					OK	Cancel
					OK	Cancel

70_ main menu