Sanyo CHDXR07263*, CHDXR09663, CHDX09663, CHDX07263 service manual Compressor

10. Compressor

W-2WAY ECO-i SYSTEM Outdoor Unit Repair Procedures

Installation

(1)Remove the 2 brazed tube caps (2 pieces) from the compressor.

(2)Remove hexagonal caps from the compressor.

* When removing the hexagonal caps, hold the fixing nut at the main unit side so as not to loose it with a wrench or spanner. And then, loosen and remove the hexagonal cap.

Hexagonal cap

Oil equalizer tube connector parts

2

Fixing nut

at the main unit side

O-ring

Fig. 26

(3)Remove the oil equalizer tube connector parts along with the O-ring from the removed compressor and mount them on the replaced new compressor.

(4)Install the crankcase heater onto the new compressor.

(5)Temporary mount 2 cushion rubbers with bolts at the position as shown in the figure 27. Set up the leg of the new compressor onto the 2 cushion rubbers.

Cushion rubbers Bolts (Temporary mounting: 2 locations

at back side, each 1 piece)

Front view

Fig. 27

2 - 32