Savin 1013 operating instructions Connecting the Network Interface Cable to the Network

Getting Started

Connecting the Network Interface Cable to the Network

Connect the machine to the network using optional Network Interface Board

1Type 1018.

Follow these steps to connect the machine.

A Confirm that you have the correct cable.

B Confirm that the machine is turned off.

C Loop the network cable. The loop should be about 15cm (6”) from the end of the cable on the end closest to the printer.

D Attach the ferrite core to the loop.

E Attach the network cable to the 10BASE-T/100BASE-TX port on the ma- chine.

Reference

See p.8 “Connecting the Machine” to confirm the position of the 10BASE- T/100BASE-TX port.

Note

❒Confirm that the cable is connected to the 10BASE-T/100BASE-TX port.

F Connect the other end of the cable to the network.

10