Error & Status Messages on the Display Panel
Messages/Second messages | Description | Solution |
Following output tray is full. | The indicated output tray is full. | Remove the paper. |
### | Note |
|
|
|
❒“###” in the message rep- resents a output tray.
HDD has a problem. | An error has occurred in the | Turn off the main power |
| hard disk drive. | switch, and on. If the message |
|
| appears again, contact your |
|
| sales or service representative. |
|
|
|
HDD has not been installed. | The Locked Print was per- | Install the hard disk if not in- |
| formed without the hard disk | stalled. If the message appears |
| installed, or the hard disk is | again after the hard disk is in- |
| damaged. | stalled, contact your sales or |
|
| service representative. |
|
|
|
HDD is full. | The maximum hard disk area | Delete unused form/font |
| size for form/font has been ex- | types. |
| ceeded. |
|
|
|
|
| An HDD overflow error oc- | Delete stored files or reduce |
| curred during Sample Print or | the file to be downloaded. |
| Locked Print. |
|
|
|
|
IEEE 802.11b (Wireless LAN) | IEEE 802.11b card was not in- | Turn off the machine and |
has a problem. | serted when the machine was | check the IEEE 802.11b card is |
| turned on, or it was pulled out | inserted correctly. Then, turn |
| after the machine turned on. | on the machine again. If the |
|
| message appears again, call |
|
| your service center. |
|
|
|
I/O buffer overflow. | The maximum size of the I/O | Increase the size of the I/O |
| buffer has been exceeded. | buffer. |
|
|
|
LCT has a problem. Turn | An error occurred in the large | Turn off the main power |
Main Power Switch off then | capacity tray. | switch, wait five minutes, and |
on. If the error appears again, |
| on again. If the message ap- |
call service representative. |
| pears again, call your sales or |
|
| service representative. |
|
|
|
dLower Staple is almost | There are a few staples re- | Load in more staples. |
empty. | maining in the lower stapler. |
|
|
|
|
An error has occurred in the | Turn off the main power | |
| optional memory unit. | switch, and on. If the message |
|
| appears again, call your sales |
|
| or service representative. |
|
|
|
Output tray has been | The output tray has been | Select the proper output tray. |
changed. | changed automatically. |
|
|
|
|
Paper in duplex unit. Open | There is a misfeed in the du- | Open the cover of the duplex |
cover and remove paper. | plex unit. | unit, and remove the misfed |
|
| paper. |
|
|
|
Paper in staple tray. Open fin- | There is paper remaining in- | Open the cover of finisher, and |
isher cover and remove paper. | side the finisher. | remove the paper. |
4
29
