Troubleshooting
30
4
Paper size and type are mis-
matched.
Specified paper size and paper
type are not loaded in the pa-
per feed tray.
Change the settings to contin-
ue the current job, or press
[Reset] to cancel the job.
Parallel I/F board has a prob-
lem.
An error has occurred in the
parallel interface board.
Contact your sales or service
representative.
Print overrun. The image data has been
thinned out due to image com-
pression.
Increase memory capacity.
When adding a memory mod-
ule to the machine, contact
your sales or service represen-
tative.
Reset duplex unit correctly. If
the error appears again, call
service representative.
The duplex unit is not set cor-
rectly, or an error has occurred
in the duplex unit.
Set the duplex unit correctly. If
the message appears again,
call your sales or service repre-
sentative.
RPCS graphic error. There is insufficient graphics
memory to print the data.
Specify the correct memory
capacity in the [Change Acces-
sories..] option in the RPCS™
printer driver's print settings
tab.
To print the image correctly,
add memory to the machine,
or reduce the resolution of the
image.
RPCS memory overflow. A memory overflow occurred
during the print job. After part
of the data is printed, the print
job is suspended.
To print the image correctly,
add memory to the machine,
or reduce resolution.
RPCS syntax error. Bidirectional transmission
may not be working properly
or the RPCS™ printer driver
settings may not be correct.
Confirm the option settings
for the printer driver match
the options installed on the
machine.
Selected paper tray is in use
for another function. Please
wait.
The specified paper tray is in
use by another function such
as copier function.
Wait until the other function
has finished using the speci-
fied paper tray.
Shift tray has a problem. Call
service representative.
A malfunction occurs when
using the shift function.
Contact your sales or service
representative.
Staple has been cancelled. Staple printing has been can-
celed.
Confirm paper feed direction,
paper orientation and stapling
position.
dStaple is almost empty. The re are a few staples re-
maining.
Load in more staples.
Staple unit is in use for anoth-
er function. Please wait.
The staple unit is in use by an-
other function such as copier
function.
Wait until the other function
has finished using the staple
unit.
Messages/Second messages Description Solution