Introduction | Savin 4018d, 4015 specification

Introduction

This manual describes detailed instructions on the operation and notes about the use of this machine. To get maximum versatility from this machine all operators are requested to read this manual carefully and follow the instructions. Please keep this manual in a handy place near the machine.

Important

Contents of this manual are subject to change without prior notice. In no event will the company be li- able for direct, indirect, special, incidental, or consequential damages as a result of handling or oper- ating the machine.

Notes Some illustrations in this manual might be slightly different from the machine. Certain options might not be available in some countries. For details, please contact your local dealer.

Laser Safety:

CDRH Regulations

This equipment complies with requirements of 21 CFR subchapter J for class 1 laser products. This equipment contains a 5 milliwatt, 760-800 nanometer wavelength, GaAlAs laser diode. This equipment does not emit hazardous light, since the beam is totally enclosed during all customer modes of oper- ation and maintenance.

Warning:

Use of controls or adjustment or performance of procedures other than those specified in this manual might result in hazardous radiation exposure.

Notes:

The model names of the machines do not appear in the following pages. Check the type of your ma- chine before reading this manual. (For details, see P.7 “Machine Types”.)

•Type 1: 4015/DSm615/LD115/Aficio 2015

•Type 2: 4018/DSm618/LD118/Aficio 2018

•Type 3: 4018d/DSm618d/LD118d/Aficio 2018D

Certain types might not be available in some countries. For details, please contact your local dealer. Two kinds of size notation are employed in this manual. With this machine refer to the inch version. For good copy quality, the supplier recommends that you use genuine toner from the supplier.

The supplier shall not be responsible for any damage or expense that might result from the use of parts other than genuine parts from the supplier with your office products.

Power Source 120V, 60Hz, 12A or more

Please be sure to connect the power cord to a power source as above. For details about power source, see P.59 “Power Connection”.

Image 2

Savin 4018d, 4015 manual Introduction

Contents

Copy Reference Introduction Manuals for This Machine Other manuals Manuals for DeskTopBinder V2 LiteManuals for ScanRouter V2 Lite Table of Contents Dos and Donts Where to Put Your Machine Accessing User Tools Copier FeaturesSettings You Can Change with User Tools If Your Machine Does Not Operate As You Want Specifications Combination Chart Supplementary InformationPage Page Remarque concernant les utilisateurs au Canada Avertissement Names of Major Options How to Read This ManualSymbols Safety Information Safety During OperationPage AAI029S Machine Types Copier only Options fully installedControl Panel Sort key Cancel keyCombine/Series key Lighter and Darker Initial copy display Reading the Display and Using KeysDisplay Scroll keys Turning On the Power Turning On the PowerTurning On the Main Power Operation switch right side of the control panel Turning Off the Power Turning Off the Main Power Auto Off/ Low Power Saving Energy Metric version Sizes and Weights of Recommended OriginalsOriginals Inch version Sizes Detectable with Auto Paper Select ADF or Ardf Missing Image AreaExposure glass Sizes difficult to detect Placing Originals on the Exposure Glass Placing OriginalsOriginal Orientation Ardf Limit mark Document guide Placing custom size originals To stop the machine during a multi- copy run Basic ProcedureTo switch between pages or select functions To clear an entered value Push up the paper guide release lever Copying from the Bypass TrayOpen the bypass tray Paper guide release lever Horizontal size Vertical size Extender Paper guides Select Paper Size using U or T, and then press the OK keySelect Regular Size using U or T, and then press the OK key Pull down the paper guide release the lever step B Feeds Select Paper Size using U orSelect Custom Size using U or T, and then press the OK key Then press the OK Select Thick Paper using U or T, and then press the OK key Copier Functions Adjusting Image DensitySelecting Original Type Setting Selecting Copy Paper Make sure Auto Paper Select is se- lected Preset Reduce/EnlargeSelect the paper tray or bypass tray using U or T Press Reduce or Enlarge ZoomBase Point Enter the ratio Adjust the ratio using U or TAuto Reduce/Enlarge Press the OK key Sort SortRotate Sort Sided → 2 Sided Optional Ardf is required Duplex Type 3 onlySided → 2 Sided Select Sort or Rotate Sort, and then press the OK key Original orientation and completed copies Press the Duplex key Sided 4 Pages → Combine 1 Side One-Sided CombineSided 2 Pages → Combine 1 Side Sided 1 Page → Combine 1 Side Optional Ardf is required Sided 2 Pages → Combine 1 Side Optional Ardf is requiredPosition of combine Orientation of the original and image Sided 4 Pages → Combine 2 Side Optional Ardf is required Two-Sided Combine Type 3 onlySided 8 Pages → Combine 2 Side Sided 4 Pages → Combine 2 Side Top or Top to Bottom using U or Then press the OK key Book→1 Sided Series CopiesSided→1 Sided Optional Ardf is required Press the Combine/Series key Select the paper tray using U or T Place your original, and then press the Start key When a Message Is Displayed If Your Machine Does Not Operate As You Want Problem Causes Solutions If You Cannot Make Clear Copies Edit If You Cannot Make Copies As You WantBasic Combine When Memory Is Full Duplex Type 3 only Push the paper tray in, until it stops Loading PaperLoading Paper Orientation-Fixed Paper or Two-Sided Paper Original Orientation Loaded paper orientation For MFP Toner Storage Adding TonerHandling Toner Used Toner Removing Toner Inserting Toner Troubleshooting Press the User Tools/Counter key Accessing User Tools Copier FeaturesChanging Default Settings Quitting User Tools Change is made, and the ma- chine is ready to copy Original Type Setting Settings You Can Change with User ToolsAuto Tray Switching APS/ Auto R/E Priority Max. Number of Sets Duplex Mode PriorityOrientation Original Count Display Duplex Margin Preset R/E PriorityLetterhead Setting Rotate Sort User Tools Copier Features Remarks Dos and Donts Optimum environmental conditions Where to Put Your MachineMachine Environment Environments to avoid Power Connection Moving Access to the Machine Cleaning the ADF or Ardf Cleaning the Exposure GlassCleaning the Exposure Glass Cover Cleaning the machine Remarks Specifications Combination Chart Bypass Tray Copy Preset Enlarge/ReduceSupplementary Information Zoom Sort, Rotate Sort Duplex Margin Type 3 only Index Combine, 34 orientation Orientation and completed copies Adding Handling Inserting Removing Storage Used Memo Means Power on EN USA B121-6607