Savin 4018d, 4015 manual If You Cannot Make Clear Copies, Problem Causes Solutions

KirC2_ENcopyF_FM.book Page 40 Monday, September 22, 2003 11:36 AM

Troubleshooting

If You Cannot Make Clear Copies

3

40

Problem	Causes	Solutions
Copies appear dirty.	Image density is too dark.	Adjust the image density. See p.26
		“Adjusting Image Density”.
	Auto Image Density is not	Adjust the auto image density. See
	selected.	p.26 “Adjusting Image Density”.
The reverse side of an orig-	Image density is too dark.	Adjust the image density. See p.26
inal image is copied.		“Adjusting Image Density”.
	Auto Image Density is not	Adjust the auto image density. See
	selected.	p.26 “Adjusting Image Density”.
A shadow appears on cop-	Image density is too dark.	Adjust the image density. See p.26
ies if you use pasted origi-		“Adjusting Image Density”.
nals.		Change the orientation of the origi-
		nal.
		Put mending tape over the pasted
		areas.
The same copy area is dirty	The exposure glass or ADF	Clean them. See p.61 “Maintaining
whenever making copies.	or, ARDF is dirty.	Your Machine”.
Copies are too light.	Image density is too light.	Adjust the image density. See p.26
		“Adjusting Image Density”.
	The paper size is not ap-	Use the recommended paper.
	propriate.	Note
		❒ A light copy may result when
		you use damp or rough grain pa-
		per.
	Toner bottle is almost emp-	Add toner. See p.47 “D Adding
	ty.	Toner”.
Parts of the paper are not	The original is not placed	Place originals correctly. See p.18
copied.	correctly.	“Placing Originals”.
	An improper paper size is	Select the proper paper size.
	selected.
Copies are blank.	The original is not placed	When using the exposure glass,
	correctly.	place originals face down. When us-
		ing the ADF or ARDF, place them
		face up. See p.18 “Placing Origi-
		nals”.
A moiré pattern is pro-	Your original has a dot pat-	Place the original on the exposure
duced on copies.	tern image or many lines.	glass at a slight angle.

R