Configuration
Control via PROFIBUS DP in native profile (CiA402)
The command and the target both come from PROFIBUS DP. Input LI3 at the terminals is used to switch between PROFIBUS DP and the terminals.
Control is in native profile (CiA402).
Configure the following parameters:
Parameter | Value | Comment |
Profile | Combined native profile (CiA402) | The run commands are in native profile (CiA402), the command and the |
|
| target come from the same channel. |
|
|
|
Target 1 configuration | Network card | Target 1 comes from PROFIBUS DP. |
|
|
|
Target 2 configuration | Analog input 2 on the terminals | Target 2 comes from input AI2 on the terminals. |
|
|
|
Target switching | Input LI3 | Input LI3 switches the target (1 ↔ 2) and the command. |
|
|
|
Configuration via the graphic display terminal or the integrated display terminal:
Menu | Parameter | Value |
[COMMAND] | [Profile] (CHCF) | [Not separ.] (SIM) |
|
|
|
| [Ref.1 channel] (Fr1) | [Network] (nEt) |
|
|
|
| [Ref.2 channel] (Fr2) | [AI2] (AI2) |
|
|
|
| [Ref 2 switching] (rFC) | [LI3] (LI3) (1) |
|
|
|
(1)LI4 to LI6 and AI1 are assignable in the menus but their value is allways forced to 0.
Control via PROFIBUS DP or the terminals in native profile (CiA402)
The command and the target both come from PROFIBUS DP or the terminals. Input LI3 at the terminals is used to switch between PROFIBUS DP and the terminals.
Control is in native profile (CiA402).
Configure the following parameters:
Parameter | Value | Comment |
Profile | Combined native profile (CiA402) | The run commands are in native profile (CiA402), the command and the |
|
| target come from separate channels. |
|
|
|
Target 1 configuration | Network card | Target 1 comes from PROFIBUS DP. |
|
|
|
Target 2 configuration | Analog input 2 on the terminals | Target 2 comes from input AI2 on the terminals. |
|
|
|
Target switching | Input LI3 | Input LI3 switches the target (1 ↔ 2) and the command. |
|
|
|
Menu | Parameter |
| Value |
[COMMAND] | [Profile] (CHCF) is configured in separate mode | [Separate] (SEP) | |
|
|
|
|
| [Cmd channel 1] | (Cd1) Channel 1 is used with the communication | [Network] (nEt) |
|
|
|
|
| [Cmd channel 2] | (Cd2) Channel 2 is used with the terminal blocks | [Terminal] (tEr) |
|
|
| |
| [Cmd switching] (CCS) LI3 is used for switching between channel 1 and 2 | [LI3] (LI3) (1) | |
| (see also the programming manual of the ATV312 for more details). |
| |
|
|
| |
(1)LI4 to LI6 and AI1 are assignable in the menus but their value is allways forced to 0. |
| ||
S1A10386 10/2009 | 17 |
