SCN60
Installation and Use
Decorating Features:
The machine ships unfinished, allowing the attachment of a decorator door panel or a metal panel from Scotsman.
Door Panel
The ice machine is supplied without a conventional door covering so it can be decorated to the user’s preference. Scotsman offers several coverings including white, black and stainless steel. In addition, a custom built panel can be placed onto the door.
Door Panels: Finished door panels are available from Scotsman for attachment to the machine, or a custom panel can be made. The panel kits are:
Kit Number | Panel Finish | Handle Finish |
KDFW | White | White |
KDFWS | White | Stainless Steel |
KDFB | Black | Black |
KDFBS | Black | Stainless Steel |
KDFS | Stainless Steel | Stainless Steel |
|
|
|
5.Place the covers over the hinge areas, and secure each cover to the door using a sheet metal screw.
6.Insert hole plug over screw installed in step 5.
7.Return the gasket to its original position.
Custom Panel
A custom panel of wood or other material not exceeding 15 lb can be attached to the door. Attachment is from the ice side of the door. Holes are provided in the door for this purpose.
See instructions in information packet to create and attach a custom panel
Door Panel Attachment
To attach a Scotsman supplied panel:
Note: If door swing is to be changed, it must be done before panel is attached.
The panel will be held on by 6 sheet metal screws and 2 machine screws.
1.Remove the gasket and retain for later use.
2.If the door panel is stainless steel, remove any plastic covering the stainless steel panel.
3.Place the panel onto the outside of the door, and secure it to the door using two machine screws, located at the left center and right center.
4.Fasten the panel to the door using the 6 sheet metal screws. In the hinge area, use the outermost screw holes.
Hole Plug
Cover
Gasket
May 2011
Page 6
