SCN60
Installation and Use
Electrical and Start Up
The ice machine is supplied with a power cord. Do not remove the grounding pin from the cord’s plug. Do not use extension cords. Follow all codes.
Connect the machine to its own 115 volt, 15 amp circuit.
1.If the electrical outlet for the ice maker is behind the unit, plug in the unit.
2.Position the unit in the installation opening.
3.Turn on the water supply. Make sure that the ice maker is plugged in and the power is on.
4.Slide unit into installation opening, paying careful attention to water supply and drain connections. Do not kink!
5.Pour a couple of quarts of water into the ice storage bin; on drain pump equipped machines the drain pump should start and water should pump out. Check for leaks.
6.Replace the service access panel.
7.Level the unit as needed.
Installation check list:
1.Has the unit been connected to the proper water supply?
2.Has the water supply been checked for leaks?
3.Has the unit been connected to a drain?
4.Has the drain been tested for flow and leaks?
5.Has the unit been connected to the proper electrical supply?
6.Has the unit been leveled?
7.Have all packing materials been removed from the machine?
8.Has the door covering been installed?
Initial Start Up
1.Turn on the water supply and check for leaks.
2.Switch on the electrical power.
3.Push and release the On/Off switch to start the machine. The Ice Making light next to the On/Off switch will glow Green.
Warm air will flow out of the left front grill.
It will take about 10 minutes for the ice machine to begin dropping nugget ice into the storage bin. It is normal for that ice to melt and ice will continue to melt, but at a slower rate. It will take about 6 - 7 hours to fill up the ice storage bin. The bin holds about 20 lb of ice when full.
Ice level control
The ice level control for the SCN60 is an ultrasonic sensor, located above the ice storage area. It is automatic and there is no adjustment to make. When ice melts or is used, and the ice level drops below a preset distance the control turns the ice making system back on. It makes ice until the preset level is reached. Placing your hand in the unit to remove ice does not affect the ice level.
May 2011
Page 11
