ALIGNMENT PROCEDURE
IMPORTANT:
IN ORDER TO OBTAIN MAXIMUM CUTTING
ACCURACY, THE FOLLOWING SIX STEPS
MUST BE CAREFULLY FOLLOWED.
BECOME THOROUGHLY FAMILIAR WITH THESE STEPS SO THAT YOU CAN ALWAYS
MAINTAIN YOUR SAW IN PROPER
ALIGNMENT. THE ACCURACY OF EACH
ADJUSTMENT IS ALWAYS DEPENDENT UPON THE ACCURA C Y OF THE PRECEDING A DJUS TMENT.
After following the 6 step assembly and alignment
procedure and the Basic Saw operation section refer to
Trouble Shooting section if any difficulty is experienced
when performing any sawing operation.
STEP ONE
NOTE: The following adjustment, performed properly, will result in the work table being parallel to the arm.
ATTACHING AND LEVELING TABLE MOUNTING SUPPORT CHANNELS.
1. Attach table mounting support channels with four square head 5/16 18 x 3/4 screws, Iockwashers and flat washers and nuts. POSITION SCREWS IN CENTER OF
CHANNEL SLOTS, finger tight to permit channels to "slip" against the base when leveling.
2.Release bevel lock lever, move bevel index pin to left and rotate the motor to position saw blade, end of shaft down Lock bevel lock.
Unlock and hold arm control lever n ndex release
position as shown. Position arm against left stop
(approximately 50 ° miter). Loosen carriage Jack knob and positior, carriage directly over left hand channel.
NOTE: For safety reasons in accordance with the UL
standard, stops have been provided to prevent 360 ° rotation of the radial arm.
4.Slide the arbor wrench handle between end of motor
shaft and mounting channel to act as a feeler gauge.
Carefully lower the motor with elevation crank until the end of shaft is just touching the arbor wrench. The
wrench should slide back and forth with only slight resistance. Tighten screw "A".
NOTE: Do qot change this elevation setting until both left and right hand table support channels have been adjusted.
5.Move arm and carriage to screw "B" and tighten support in the same manner.
6.Move arm and carriage to right hand support channel and level in the same manner you adjusted the left hand support channel.
7.Recheck both support channels to make sure that
tightening screws did not affect the accuracy of the adjustment.
8.Elevate saw and place motor in vertical position to
provide clearance for installation of front (work) table.
TABLE MO r'4TING
S JPPORT CHANNEL
\
SCREWS
HERE
LOCKWASHER
FLAT WASHER
BASE
MOUNT RAILS LJSIING
THESE HOLES
o
ARBOR WRENCH
SCREW "A"
ARBOR WRENCH
TABLE MOUNTING
SUPPORT CHANNEL
(LEFT HAND)
SCREW "8"
SCREW "A"
12
