assembly and alignment
ALIGNMENT OF SPREADER FOR RIPPING.
WARNING: NEVER POSITION THE GUARD OR
ANTIKICKBACK ASSEMBLY WITH POWER ON; NOR
POSITION ANTIKICKBACK PAWLS BY GRASPING
PAWLS OR SPREADER.
2.Install Blade Guard.
a.Sight (visually) to check for proper alignment of spreader with saw blade as shown. If the spreader is not aligned, adjust it as follows:
(I)Loosen two hex nuts, one on each side of spreader.
(2)Rotate hex nuts with fingers until the spreader is directly in line with saw blade.
(3)Tighten both hex nuts firmly.
_ i
",_ WING SCREW
PREADFR
J
3.Check and Adjust the spreader as follows:
a. Loosen the antikickback spreader adjusting wing screw and with the "tab" position the antikickbaek and spreader assembly near the bottom of the blade and tighten.
ANTI KICKBACK, SPREADER
ADJUSTING WING SCREW
TAB
OUTSIDE VIEW | INSIDE VIEW |
ANTIKICKBACK PAWLS
FENCE LOCATIONS
Position (A) is used for most cutoff and narrow ripping
operations. Position (B) is used for maximum width
ripping. Position (C) is used to achieve maximum crosscut capacity in thin work.
Now that you have assembled and aligned your saw, you are ready to proceed with operating controls section of this manual. Refer to trouble shooting section if saw does not
perform satisfactorily or any problems should surface after using the saw.
B CA
19
