Sears 113.19771 owner manual Containing the following Items, Truss Hd /4-20 Lockwasher, 1/4

ThefoliowingpartsareincludedwithModel113.197751.

Key
No.	Table of			Loose Parts			Qty.
1	Leg						4
2	Stiffener,			L.H			4	2
3	Stiffener,			R.H			4	3
	Loose Parts Bag Part No. 63752
		(containing the following				items):
4	-	Screw,		Truss Hd. 1/4-20		x 5/8	40
5	-	Lockwasher, 1/4			External		40	4
5	-	Lenkwasher, 5/16			External		4
6	-	Nut,	Hex 1/4-20		.........................		40
6	-	Nut,	Hex Jam 5/16-18			....................	4
6	-	Nat, Hex 1/2-13			.........................		8
7	-	Foot,		Leveling			4
8	-	Screw,		Hex Hd. 5/16-18		x 5/8	4
9		Washer, 11/32 x 11/16				x 1/16	16	7

ASSEMBLING STEEL LEGS

NOTE: Steel Legs are furnished with Model 113_197751.

From among the loose parts, find the following Hardware:

40 Truss Head Screws. 1/4-20 x 5/8

40 Lockwashers, 1/4-External

40 Hex Nuts, 1/4-20

8Hex Nuts, 1/2-13

4Leveling Feet

Assemble the Legs as shown.

1. Assemble Two (2) each of right and left hand Stiffeners
to the length shown using 1/4-20	x 5/8" truss head

I-

oo

o

STIFFENER

L.H.

I°O O

0 0

00

STIFFENER

R.H.

0 O t O O	°1
I
I

screws, tockwashers and hex nuts.

O

o

O O II O O

2.	Attach	the four	(4)	legs	to	the	Stiffeners	using	1/4-20
	screws,	Iockwashers		and	nuts.
3.	Install leveling feet as shown. To level steel legs, loosen
	nut on	inside of	leg	and	turn	nut	on outside to		raise or
	lower feet. Adjust all four levelers if necessary, and then
	tighten	nuts on inside of leg.

NOTE: These levelers are not intended for height adjustment.

CAUTION: Leveling feet must be adjusted so the saw does

not rock AND so that the arm slopes slightly downward to the rear so the carriage will not rotl forward due to gravity.

SflFFENER

L.H.

32

STIFFENER

R.H.

12

/

1

1