Sears 113.19771 owner manual OHPtArED O

Loosen (2) V4 20 Gib set screws on the left side at the rear of the column support,

3.Elevate, and then lower the Arm: (a) if the column

binds and elevation is difficult loosen two 5/16 - 18 plated bolts on front side of the column support until

you achieve smooth but firm elevation. (b) If the column moves side-to-side within the column support, tighten the two 5/16 -- 18 plated bolts until movement disappears - elevation should be smooth and firm.

4.Now tighten the (2) Yf, 20 Gib set screws until no

noticeable rotational play exists between Column Tube and Column Support.

5.Recheck elevation and re-adjust if necessary.

6, Replace Column Support trim.

B ,OHPtArED O

BLADE

ROTATION 1

STEP THREE

SQUARING CROSS CUT TRAVEL (CARRIAGE

TRAVELS IN A STRAIGHT LINE).

1.Index but do not lock arm at 0 ° miter.

2.Install saw blade as shown. Motor shaft has left hand threads.

NOTE: Do not overtightenarbor nut. Use the arbor wrench to just "snug" it.

SHAFT WRENCH

o END OF ARBOR WRENCH Rf_STING ON TABLE

SAW BLADE	_..__
OCTEF_ COLLAR	__	iii	_._	MOTOR
ARBOR NUT	_INNER			COLLAR

14