Seiko Group FB300 manual Interface Type, Input Buffer, Ignore PE, Autofeed Signal, SLCT-IN Signal

Setup Parameter	Values	Description
INTERFACE TYPE	parallel, serial, automatic,	Selects the interface type. In case of ‘automatic’ the interface
	auto+blink	type is selected by the printer depending on data coming from
		host. When the auto+blink item is selected, the P1 and P2
		leds blink to indicate which interface is selected: P1 blinks
		when the parallel interface is selected, whereas P2 blinks,
		when the serial interface is selected.
INPUT BUFFER	1 Kb, 8 Kb, 16 Kb, 32 Kb	Selects the buffer size.
IGNORE PE	enabled, disabled	Selects whether the printer signals the paper empty condition
		(disabled) or not (enabled).
AUTOFEED SIGNAL	disabled, enabled	The parallel interface uses (enabled) or does not use
		(disabled) the AUTOFEED signal.
SLCT-IN SIGNAL	disabled, enabled	The parallel interface uses (enabled) or does not use
		(disabled) the SELECT-IN signal.
BUFFER CONTROL	DTR+SRTS, SRTS,	Selection of the buffer protocol.
	XON/XOFF,
	XON/XOFF+DTR+SRTS
ROBUST XON	enabled, disabled	Perform the Robust XON (enabled) or not (disabled).
WORD LENGTH	7 bit, 8 bit	Sets the number of the data bits.
BAUD RATE	600 - 38400 bps	Sets the data transfer rate.
PARITY BIT	even, odd, none	Selects the parity control for the data.

34