Sennheiser ew500 manual Battery status indication, Changing the microphone module

Battery status indication

The red LED and the lower 8-segment bargraph on the display provide information on the (remaining) battery capacity.

Bargraph:

The bargraph indicates the (remaining) battery capacity in 3 steps:

8 segments:	the full battery capacity is available,
4 segments:	the battery capacity is sufficient,
1 segment:	the battery is going flat,
	immediately replace the battery.

Note:

When switching on the transmitter with a partially used battery, it is possible that all eight segments may show for a short period of time – if this happens, re-check battery status after a few moments.

LED lit up:

The transmitter is switched on and the battery capacity is sufficient.

LED flashing:

The battery is going flat! You should immediately replace the battery!

Changing the microphone module

￿First remove the battery and leave the radiomicrophone open.

￿Unscrew the sound inlet basket.

￿Loosen the screw and put it aside.

￿Remove the microphone module, as shown. Do not touch the contacts!

￿Insert the new module, secure the capsule by tightening the screw, put on the suitable sound inlet basket and coloured identification ring and screw it tight.

￿Insert the battery, close the radiomicrophone and put it into operation.

Note:

Microphone module, sound inlet basket and foam insert form an acoustic unit and must therefore always be exchanged all together. Each microphone module comes with a colour-coded identification ring to distinguish different microphone modules from each other (green = MD 835, blue = MD 845, red = ME 865).

69