Sennheiser ew500 Signal and battery status indication, Battery status indication, LED lit up

Switching the receiver on/off

￿ Slide back the cover plate .

￿Press the ON/OFF button to switch the receiver on. The red LED lights up.

￿To switch the receiver off, press the ON/OFF button until “OFF” appears on the display. You can then release the button. The red LED goes off.

Signal and battery status indication

The green LED	at the top of the EK 500 receiver indicates that an RF
signal is being received.
Battery status indication
The red LED	provides information on the (remaining) battery capacity:

LED lit up:

The receiver is switched on and the battery capacity is sufficient.

LED flashing:

The battery is going flat! You should immediately replace the battery!

Attachment of the receiver to clothing

The EK 500 receiver is best attached to e.g. the belt with clip .

The clip is detachable so that you can also attach the receiver with the antenna pointing downwards. To do so, withdraw the clip from its fixing points and attach it the other way round.

Attachment of the receiver to a camera

Use the supplied camera kit (self-adhesive Velcro tape) to attach the receiver to a camera. Remove the clip and stick the Velcro tape to the receiver and the camera. Ensure that the surfaces are clean and free from grease.

(Note: We would suggest using the “hook” Velcro on the receiver and the “loop” Velcro on the camera).

60