Sennheiser ew500 manual Connecting the microphone/line cable, Switching the transmitter on/off

Inserting and changing the battery
￿	Slide the cover of the battery compartment	in the direction of the
	embossed arrow until it clicks audibly.

￿Open the cover.

￿Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity when inserting the battery.

￿Close the battery compartment.

￿ To remove the battery, push the small red lever in the battery compartment towards the bottom side of the transmitter.

Note:

We recommend powering the transmitter by a standard PP3 alkaline battery. If powered by a rechargeable 9 V battery, the operating time will be drastically reduced.

Connecting the antenna

￿ Screw the antenna onto the antenna socket (M3 connection).

Connecting the microphone/line cable

Electret powering (“plug-in” power) is available at the AF input for powering the microphone.

￿	Connect the 3.5 mm jack plug from the microphone/line cable to
	the AF input (MIC/LINE) .
￿	Lock the jack plug by screwing down the locking ring .

Switching the transmitter on/off
￿	Slide back the cover plate .
￿	Press the ON/OFF button	to switch the transmitter on. The red
	LED lights up.

￿To switch the transmitter off, press the ON/OFF button until “OFF” appears on the display. You can then release the button. The red LED goes off.

Muting the transmitter
Use the MUTE switch	to noiselessly mute the transmitter’s audio signal

(this switch does not switch off the transmitter).

62