Recommendations and tips

... for the ME 2 and ME 4 clip-on microphones

To reduce level variations to a minimum when the user turns his or her head away from the microphone, attach the microphone as centrally as possible.

To protect the microphone against excessive sweat/moisture, avoid direct skin contact.

Attach the microphone carefully and conduct the cable such that noise due to friction is avoided.

Always use the ME 4 directional microphone with a windshield and direct the microphone towards the sound source (e.g. mouth).

... for the ME 3 headmic

Always use the microphone with a popshield and position the microphone at the corner of the mouth.

You can vary the bass reproduction by increasing/decreasing the talking distance.

Make sure that the sound inlet is directed towards the mouth. The sound inlet is marked with a little dot.

... for the SK 500 pocket transmitter

Make sure that the antenna and the microphone cable do not cross.

The antenna should hang freely and be at least 1 cm away from the body. The antenna must not be in direct contact with the skin.

For best results, make sure that the transmitter sensitivity is correctly adjusted.

... for the SKM 500 hand-held transmitter

Hold the SKM 500 hand-held transmitter in the middle of the microphone body. Holding it close to the sound inlet basket will influence the microphone’s pick-up pattern, holding it at the lower part of the body will reduce the transmitter’s range.

You can vary the bass reproduction by increasing/decreasing the talking distance.

For best results, make sure that the transmitter sensitivity is correctly adjusted.

84

Page 87
Image 87
Sennheiser ew500 manual Recommendations and tips, For the ME 2 and ME 4 clip-on microphones, For the ME 3 headmic