Plug-in mains units, ΔU method | Sennheiser LV307, LV308 manual

Specifications

		ΔU method
		Deep discharge recovery charge
	Charging principle:	Trickle charge
	Charging principle:	rechargeable battery temperature monitoring
		rechargeable battery temperature monitoring
		Over/undercharge detection
		Charging time limit (max. 6 h)

		approx. 2.5 h with a totally
	Charging time:	discharged rechargeable battery and at room temperature,
		automatic security switch-off after 6 h at the latest

	BA 2015 battery type:	2 x 1.2 V 1500 mAh, NiMH

	Dimensions:	approx. 145 x 80 x 110 mm

	Weight:	approx. 310 g

Plug-in mains units

Plug-in mains unit for 1 charger

Plug-in mains unit for up to three chargers

NT 1-EU (Cat. No. 09828), 230 V ±10 %, 1,8 A, 50 Hz NT 1-UK (Cat. No. 04787), 230 V ±10 %, 1,9 A, 50 Hz

NT 3-EU (Cat. No. 04863), 230 V ±10 %, 1,8 A, 50 Hz NT 3-UK (Cat. No. 04864), 230 V ±10 %, 1,9 A, 50 Hz

evolution wireless transmitters G 2

Modulation

Frequency ranges

Transmission/receiving frequencies

RF output power at 50 Ω

Power supply

power consumption at nominal voltage Operating time

wideband FM

518–554, 626–662, 740–776, 786–822, 830–866 MHz

8 channel banks with up to 20 factory-preset channels each

1 channel bank with up to 20 freely selectable channels (1440 frequencies, tunable in steps of

25kHz) typ. 30 mW

2AA size batteries, 1.5 V

≤170 mA

>8 h (SKP 500 G2 with P48 > 5 h)

SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophone

Dimensions	∅ 50 x 225 mm

Weight	approx. 450 g

SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitter

Max. input voltage (at peak deviation)	MICRO: 1.8 Vrms (unbalanced)
Max. input voltage (at peak deviation)	LINE: 2.4 Vrms
Dimensions	82 x 64 x 24 mm

55

Image 55

Sennheiser LV307, LV308 Plug-in mains units, Evolution wireless transmitters G, ΔU method, Deep discharge recovery charge

Contents

Tourguide UHF Page Contents Thank you for choosing Sennheiser Important safety instructions Overloading Power sourceReplacement parts Safety check Do not solder Safety instructions for Lithium-Ion rechargeable batteries System components Tourguide UHF system EK 1038 receiver Special featuresOperating controls Indications Operation and battery status indicationSegments Capacity approx % Battery icon flashing LOW BAT RF signal indication Preparing for use Inserting and changing the battery pack/batteriesHow to properly use the battery pack or the batteries Connecting the headphones Switching the channel Using the receiverSwitching the receiver on/off Adjusting the volume Attaching the receiver to clothing Configure the receiverMenu is given within the chapter The setup menu Operating menu of the receiver Function of the buttons in the setup menu Starting the setup menu Software stored on a chip in the device Getting into the operating menu of the setup menuGetting into the setting mode of a menu Selecting a menu Exiting the setup menu Adjusting a settingStoring a setting Canceling the entry LOC. OFF LOC. on Setup menu of the receiver Changing the receiving frequencies of the channels Adjustment tips for the setup menuActivating/deactivating the lock mode Locking channels for the user Releasing locked channels Adjusting the squelch threshold Displaying the revision of the firmware Limiting the volume at the headphone outputCopy function Slave Quick charger LED indications Do not place the receiver on delicate surfaces Setting up the chargerSwitching the charger on or off Cascading several chargers Compartments As shown Red LED Using the chargerCare and maintenance Charging the rechargeable battery BA SK 100 G2 / SK 300 G2 / SK 500 G2 Channel bank system Quick charger Delivery includes SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophones Changing the microphone module Inserting and changing the battery Switching the radiomicrophone on/off Using the radiomicrophone Muting the radiomicrophone SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitters Inserting and charging the accupack Positioning the microphones Connecting the microphone/line cableAttaching the microphones Use the microphone clips Play appears on the display panel Using the bodypack transmitterSwitching the transmitter on/off Muting the transmitter Microphone input, XLR-3 socket Button UP Unbalanced SKP 100 G2 / SKP 500 G2 plug-on transmitters Plugging the transmitter onto the microphone Betriebs- und Batterieanzeige Mute display LC display panel Evolution wireless transmitters GBattery status indication LC display panel Display backlighting Pilot display Buttons Overview of menus Getting into the operating menu Working with the operating menuExiting the operating menu Overview of the operating menu of the transmitters Exit Disply Selecting the frequencies to be stored in the channel Switching between channel banksSwitching between the channels in a channel bank Adjusting the sensitivity SKP 500 G2 only Switching the phantom powering on/off Selecting the standard display Loading the factory-preset default settingsEntering a name Activating/deactivating the pilot tone transmission Activating/deactivating the lock modeExiting the operating menu Deactivate the muting function TroubleshootingError checklist Set transmitter and receiver to …for the bodypack transmitters Recommendations and tipsFor the receiver EK For the radiomicrophones Progress you can hear HDX noise reductionInherent Quick charger Accessories and spare parts SKP 100 G2 / SKP 500 G2 plug-on transmitter SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitter EK 1038 receiver Specifications2015charger Plug-in mains units Evolution wireless transmitters GDeep discharge recovery charge Automatic security switch-off after 6 h at the latest Tune Chan Channel assignment Manufacturer declarations Warranty Statements regarding FCC and industry Canada Weee Declaration Manufacturer declarations