Sennheiser LV308, LV307 manual Limiting the volume at the headphone output, Copy function

Using the receiver

Note:

yIf the squelch threshold is adjusted too high, the transmission range will be reduced. Therefore, always adjust the squelch threshold to the lowest possible setting.

yWhen in the setting mode of the “SQELCH” menu, pressing the

button for more than three seconds will switch the squelch off. “SQ.OFF” flashes on the display. If no RF signal is being received, hissing noise will occur. This setting is for test purposes only.

LTD	Limiting the volume at the headphone output
	Via the “LTD” menu, you can switch the limiter on and off. With the
	limiter switched on, the maximum possible volume of the head-
	phone output will be reduced about approx. 15 dB.
	Note:
	The receiver is preset so that the limiter is switched on. We rec-
	ommend to keep the limiter switched on all the time.
SW-REV	Displaying the revision of the firmware
	Via the “SW-REV” menu, you can display the revision of the
	firmware installed in the device.
	The revision displayed is only relevant to the Sennheiser Service
	department.
COPY	Copy function
	Note:
	If the “COPY” menu is not available on your receiver, please
	contact the Sennheiser Service department.
	Via the “COPY” menu, you can copy all configuration settings of one
	receiver (master) to an arbitrary number of other receivers (slaves),
	allowing you to quickly and easily transfer a receiver configuration
	to other receivers in the system.
	To prepare a receiver with “master” function:
	Select one receiver.
	Set the desired channel and all other receiver settings.
	Change to the “COPY” menu.
	This receiver takes over the “master” function.
	To prepare a receiver with “slave” function:
	Open the battery compartment cover of all receivers to which
	you want to transfer the settings (slaves).
	Switch on all receivers.

20