Siemens 200 Checking Volume Characterization MR, Checking OCM Flow Characterization MR, Press

Testing the Configuration

3.Press the ARROW or to adjust the simulated rate of rise or fall, based on the chart on page 86. The maximum rate is 4% of Span / second.

The effect of the ARROW key is determined by the state (rate of rise or fall) immediately before the key is pressed.

Action	State (prior to pressing key)	Effect
	Stop	Rise at 1% of Span / second
	Rise at 1% of Span / second	Rise at 4% of Span / second (max.)
Press	Rise at 4% of Span / second (max.)	No effect
	Fall at 1% of Span / second	Stop
	Fall at 4% of Span / second	Fall at 1% of Span / second
	Stop	Fall at 1% of Span / second
	Rise at 1% of Span / second	Stop
Press
	Rise at 4% of Span / second (max.)	Rise at 1% of Span / second
	Fall at 1% of Span / second	Fall at 4% of Span / second (max.)
	Fall at 4% of Span / second (max.)	No effect

When the level rises to 100% or falls to 0%, it reverses direction at the same rate.

Checking Volume Characterization [MR 200]

To confirm universal volume calculations (P050 = 9, 10) are correct:

1.Go to P920.

2.Key in a level associated with a known volume.

3.Press ENTER .

4.Check the returned volume against the manufacturer’s chart.

5.Change parameters P054 and P055, as required.

6.Repeat steps 2 to 5 until the volume curve is verified.

Checking OCM Flow Characterization [MR 200]

To confirm universal flow calculations (P600 = 4, 5) are accurate:

1.Go to P925.

2.Enter a level with a known flow.

3.Press ENTER .

4.Check the returned flow against the manufacturer’s chart.

Page 86 MultiRanger 100/200 – INSTRUCTION MANUAL 7ML19981FB06