Siemens 200 Master Reset P999, P927 Distance Measurement, Pressing the Clear keys 7ML19981FB06

P927 Distance Measurement

The distance between the surface and the transducer face (displays only as % of Empty).

Primary Index	Transducer
Values	Range: 0.000 to 9999% (Displays as % of Empty) (view only)
Related	•	P005 Units
	•	P006 Empty

Use P923 unless the distance information is required in percent.

Master Reset (P999)

This feature resets all parameters to original values.

Primary Index	Single Point Model	Dual Point Model
	Global	Transducer
Values	See below.

Use this feature prior to initial programming if arbitrary Parameter Values were used during a bench test, or after upgrading the software. Following a Master Reset, complete reprogramming is required.

To perform a Master Reset, access P999 and press CLEAR . C.ALL displays until the reset is complete.

In dual point units, both points can be reset at the same time by setting the index to 00

and pressing the CLEAR keys.

CAUTION: be careful when using this feature. All data for all points will be reset. For convenience, be sure to record the values you want to re-enter.

7ML19981FB06 MultiRanger 100/200 – INSTRUCTION MANUAL Page 221

Parameters